ACCU-CHEK Multiclix Lancet Device User Manual

ACCU-CHEK Multiclix Lancet Device User Manual

Using your ACCU-CHEK® Multiclix Lancet Device

Testing From Your Fingertip

1. Remove the blue cap.
   Note the position of the thumb and index finger in the picture.

2. Insert a new lancet drum blue ring first, until it stops and clicks into place.
   Note: Before inserting a lancet drum, be sure the device is not primed. (The release button should be clear, not yellow.)

3. Slide the cap on until it stops.
   Align the notch on the cap with the notch on the device

4. Adjust the depth.
   Turn the Comfort Dial™ to start at 2 or 3. For tougher skin, dial to a higher number.

5. Prime the lancet device. Press the plunger in as far as it will go, like a pen. The release button turns yellow when the device is ready.

6. Hold the lancet device firmly against the side of your fingertip. Press the yellow release button. Remember, the lancet does not come out of the center of the cap.

7. Advance to a new lancet.
   For virtually pain-free testing, always use a new lancet. (See other side for instructions on how to load a new lancet.)

Using your ACCU-CHEK® Multiclix Lancet Device Testing From a Site Other

Than Your Fingertip Some blood glucose meters test from sites other than your
fingertip, such as palm, forearm, upper arm, thigh, or calf.*

1.  Slide the clear cap on by aligning the notch 1 on the cap with the notch on the lancet device. Be sure a lancet drum is loaded.

2. Prime the lancet device. Press the plunger in as far as it will go, like a pen.The release button turns yellow when the device is ready.

3. Press the lancet device firmly against the skin. Pump the lancet device slowly up and down to increase circulation.

4. Press yellow release button while maintaining firm, steady pressure to assist blood flow until an adequate drop of blood forms.

More Tips for Testing From a Site Other Than Your Fingertip

• Between steps 2 and 3, rub the skin prior to lancing to increase blood flow.
• If you experience difficulty obtaining a sufficient drop of blood, contact our ACCU-CHEK Customer Care Service Center. We will guide you through the testing procedure step by step.
•  Refer to your owner’s booklet or contact your doctor to learn more before testing from sites other than your fingertip.

For virtually pain-free testing, always use a new lancet.

To load a new lancet:
A. Twist the plunger 1 4 turn forward until it stops, then twist back all the way.

B. The lancet counter will decrease by one white bar. When no white bars are visible, you are using the final lancet.

C. To remove the drum:
Take the cap off and pull the drum straight out. Once removed, a lancet drum cannot be reinserted.
To insert a new drum: See the other side for instructions.

The ACCU-CHEK Customer Care Service Center

is available 24 hours a day at 1-800-858-8072.
For a virtual product demonstration, go to accu-chek.com
ACCU-CHEK MULTICLIX is a trademark of a Member of the Roche Group. 362-24387-0205 ©2005 Roche Diagnostics. All rights reserved. 04582900001

Read More About This Manual & Download PDF:

References

• Accu-Chek Diabetes Care Products Home | Accu-Chek

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>