HOMCOM 824-010V70 Pedestal Fan with Mist Instruction Manual

IN221000625V01_UK
824-010V70 Mist Fan, 16 Inch 230V.50Hz, 90W ****

824-010V70 Pedestal Fan with Mist

IMPORTANT. RETAIN FOR FUTURE REFERENCE READ CAREFULLY
Dear customer,
Thank you for purchasing this product. So that your appliance serves you well, please read all the instructions in this user’s manual. If you have any questions, please contact our customer care center,Our contact details are below:

enquirices@mhstar.co.uk

WARNINGS

INSTRUCTION FOR USE
Please read these Operating Instrutions carefully before connecting your device to the mains, in order to advoid damage due to incorrect use. Please pay particular attention to the safety information. If you pass the device on to a third party, these Operating Instructions must also be handed over.
WARNING-When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electrical shock and personal injury.
SAFETY INFORMTION

1. Incorrect operation and improper handling can lead to faults on the device and injuries to the user.

2. In the event of improper use or incorrect handling, no liability can be accepted for any damage that may occur.

3. Before you put the plug into the socket, please check that the type of current and mains voltage correspond to the instructions on the rating label on the underside of the appliance.

4. Do not immerse the unit or mains plug in water or other liquids.
   There is danger to life due to electric shock! However, if this should occur, remove the mains plug immediately and then have the unit checked by an expert before using it again.

5. Do not operate the device if the mains cable or the mains plug show signs of damage, if the device has fallen on the floor or has been otherwise damaged. Insuch cases take the device to a specialist for checking and repair, if necessary.

6. Never remove the mains plug from the socket by pulling on the mains cable, or with wet hands.

7. Ensure that the mains cable does not hang over sharp edges or allow it to become trapped.

8. Keep the appliance away from humidity, and protect from splashes.

9. Keep the appliance away from hot objects (e.g. hotplates) and open flames.

10. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly.

11. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision of instruction concerning use of the appliance in a safe way and understand the hazards involved.

12. Children shall not play with the appliance.

13. Cleaning and user maintenance shall not be made by children without supervision.

14. Keep the appliance and its cord out of reach of children of less than 8 years.

15. The appliance should not be operated by means of an external timer – switch or by means of a separate system with remote control not originally belonging to this appliance.

16. Use the appliance on a flat, dry and heat resistant surface.

17. This appliance is intended to be used in households and similar applications.

18. Never leave the device unattended during use.

19. Do not store or operate the appliance in the open air.

20. Keep the appliance in a dry place, inaccessible to children (in its packaging).

21. Never put fingers or any other objects through the grilles (fan guards) when the fan is running.

22. The appliance must be assembled completely before use.

23. Watch out for long hair! It can be caught in the fan owing to the air turbulence.

24. Do not point the air flow to the people for a long time.

25. Ensure that the fan is switched off from the supply mains before removing the guard.

Technical information

1. Misting Board
2. Front Grill
3. Blade Lock Nut
4. Blade
5. Back Grill
6. Grid Ring
7. Grill Lock Nut
8. Motor Shell
9. Oscillation Button
10. Back Shell
11. Nut
12. Panel
13. Switch
14. Misting Tube
15. Top Cap
16. Water Tank
17. Tank Bracket
18. Knop
19. Base
20. Weight Rubber
21. Wheels
22. Screw
23. Gasket
24. Support Tube

Instructions for use

1. Insert the support tube (24) into the base (19), and tight up by the screw (16) and the gasket (23).
2. Insert the main body into the support tube (24), and tight up by the nut (11).
3. Insert the 4pcs wheels (21) into the weight rubber (20).
4. Put the back grill (5) on the motor shell (8), and tighten up by the grill lock nut (7) to the motor cover. Insert the blade (4) on the motor shaft, and tighten up by the blade lock nut (3).
5. Fixed the misting board (1) on the front grill (2), and tight up by misting board lock screws.
6. Connection the front grill (2) and back grill (5) by grid ring (6), and tighten up by grill lock nut .
7. Insert the misting tube (14), connection to the misting board (1)

Fill the water tank:
Unscrew the valve cover to open the tank turning it anticlockwise, fill the tank with cold and clean water making sure not to overfill it. To close the tank, screw the valve cover back on securely turning it clockwise . ATTENTION!

• Make sure the product is unplugged from the mains before filling or refelling the water tank.
• Only use water in the water tank. Do not add any chemicals, oils or other additives.
• Only use cold or lukewarm water in the water tank. The water must not be warmer than 40°C.

Control panel

SPEED Button:

• There is 3 speed of the fan for choose:
  0 – It’s the power offer button to stop the fan working
  1- Low
  2- Medium
  3- High

MIST Button :

• Put some water into the water tank (16), and tighten up the lock nut. And put it back to the fan.
• When the mist function is selected the water indicator light on in blue color .
• If the water tank (16) is empty (No water), the indicator light will be light on in red color.

Noted: The mist function and speed function can be worked independent, or together.

OSCILLATION Button:

• Press the oscillation button (9) to activate the automatic oscillation from right to left.
• Handup the oscillation button (9), the oscillation will be stop.

CLEANING AND MAINTENANCE

NOTED: Before cleaning the appliance always disconnect the power plug from the receptacle.

1. DO NOT dip the device in water, or splash it with any other liquids.
2. DO NOT use solvents or any other chemical products for cleaning it. When you do not use it, after cleaning it, store the fan in a dry place.
3. When you have finished using the fan at the end of the season, wipe off any dust to maintain it in good working order for the next season; if necessary disassemble the grille and remove the fan; clean them with a soft damp cloth.
4. Remove the water tank and clean it with lukewarm water; before replace the water tank in the unit make sure it is completely dry.

DISPOSAL

Used electric household devices

1. If you do not want to use your electrical appliance any longer, return it free of charge to a recycling depot for used electric appliances.
2. Used electric devices do not belong in the household garbage (see symbol)

Further disposal instructions

1. Return the electrical appliance in such a condition that its later re-use or recycling is not adversely affected. Batteries must be removed in advance and the destruction of parts which contain fluids must be avoided.
2. Electrical appliances can contain harmful substances. Improper handling or damage to the appliance can lead to health problems or water or ground contamination, when the appliance is recycled later.

SPECIFICATION

Product: Mist Fan
Model: TSP40-MC
Power: 90W
Voltage: 230V / 50Hz
Made In China

All images serve as illustrations only and do not always show exact representations of the device.
All rights reserved.
Imported by Aosom LLC
27150 SW Kinsman Rd Wilsonville, OR 97070 USA
Manufactured in Ningbo City, Zhejiang Province, China
MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>