finder Tipo 1C.B1 Termostato Smart User Manual
- June 12, 2024
- finder
Table of Contents
finder Tipo 1C.B1 Termostato Smart User Manual
INSTALLATION
-
Connect the Micro USB connector to the Gateway and the power supply to the electrical outlet.
After switching on, the Gateway’s luminous base will flash with a fading white light, awaiting configuration.
YESLY: Use the YESLY APP Finder to configure the Gateway, only aftercreating the Yesly system with the TOOLBOX PLUS App Finder.
For more information: yesly.life/setup-gateway
SMART BLISS2 THERMOSTAT: Use the FINDER BLISS application toconfigure the Gateway and the Smart Bliss2 Thermostat. For more information: yesly.life /setup-bliss2
-
LUMINOUS BASE
WHITE LED
– Flashing fading: waiting for configuration
– Fixed: connection established with both the Wi-Fi network and the Cloud
– 2 flashes: connected only to the Wi-Fi network – no connection to the Cloud (internet not active)
– 3 flashes: no connection to the Wi-Fi network and no connection to the Cloud (internet not active)
BLUE LED
Flashing: sending Bluetooth commands to the devices
RED LED
Flashing: commands are sent to the Smart Bliss2 thermostat -
GATEWAY SETTING
To change the light intensity of the GATEWAY base:
– press the button once: Low brightness
– press the button twice: Medium-Low brightness
– press the button 3 times: Medium-High brightness
– press the button 4 times: High brightness
RESET
Press the button for > 10 seconds to reset the settings to factory