TRAGLO46608 Splash M BT TWS Speakers Tracer Bluetooth Instruction Manual

: June 4, 2024
: Tracer

Table of Contents

TRAGLO46608 Splash M BT TWS Speakers Tracer Bluetooth
Introduction
Points for attention
Bluetooth mode
Charging
Specification parameters
Package Includes
List of key functions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TRAGLO46608 Splash M BT TWS Speakers Tracer Bluetooth

Introduction

Thank you for using our company’s products, in order to enable you to operate the speaker as easy as possible. Please read this manual carefully before you begin to use it. The Speaker is a fashion portable wireless Bluetooth speaker with a waterproof designed, This speaker can bear rain.,it is very suitable for outdoor travel. Support Bluetooth 5.0 protocol, support for smartphones, tablets, and notebooks that with bluetooth audio equipment, allowing you to completely get rid of a wire harness restraint, freely enjoy music, also supports U-dsik, and without Bluetooth mobile phones, notebook computers, MP3, MP4 and other audio input equipment.

Points for attention

Do not hit or crush it seriously.
Do not contact benzene, diluent and other chemicals.
Do not use near by strong magnetic field or electric field.
Avoid direct rays or heating appliances.
Do not disassemble, repair or modify.
Do not listen at large volume for long periods of time, so as not to injure the hearing.
Do not clean the speaker with water and don’t immerse the speaker in the water. This speaker only has water pray prevention function. If use the speaker not by the right way and cause any quality problems, not support warranty. Kindly note above!. Please clean the speaker with a slightly damp cloth.
When using cycling, driving a car or motorcycle, Please don’t stand in the rain for a long time.
When using at low voltage, it may cause distortion of sound and please charge it in time.
Bluetooth is compatible with common smart phones and tablets, but depending on the device or application you use, may not be able to support a particular feature.

Buttons information with Interface:

TRAGLO46608-Splash-M-BT-TWS-Speakers-Tracer-
Bluetooth-1

Long press Off/on, short press switch modes to BT/U-disk and Aux.
Next song /volume up. Short press to next song, long press to up volume.
1. short press to pause/ tell, pause/ play; 2. Long press to cancel or set-up TWS function; 3. When in FM radio mode, Short press to automatic channel search /Long press to cancel search; 4. Double click last No to redial, short press pause/ play; When incoming call, short press answer/hang up, long press reject.
Previous song/ volume down. Short press to previous song, long press to down volume.
Led.
U-disk interface.
Audio in charge.
Charger interface.

Bluetooth mode

Bluetooth version: Bluetooth 5.0, supports HSP,HFP,A2DP protocol, with English prompt voice, and bluetooth device name TRACER Splash M.
Press switch button (2 seconds),on or off. After the opening, speaker makes a prompt voice, the blue light flashes quickly, and the speaker goes into bluetooth mode.
The blue light flashes by quick into the matching state and the phone searches for the name of the TRACER Splash M device to connect. If you need the password, enter it (0000), when the connection is successful the blue light is always bright and speaker indicate a successful sound. The blue light flashes slowly during the music playing. Once the paired phone turns on bluetooth and then automatically reconnects the speakers.

AUX In mode

Insert AUX In automatically into AUX In mode and the blue light flashing by slow.

U-disk mode

Once speaker has inserted the U-disk and automatically switched to music mode.

FM Radio mode

Short press to on/off of button, can switch to FM modes.

How to set-up TWS function:
Power on two same speakers at same time. And make sure the two same speakers are in bluetooth mode. Two same speakers will pair bluetooth each other automatically. You will hear indication voice “Dong” around 3 seconds later. It means TWS funcion set-up successfully. If want to cancel or set-up TWS function again, just keep pressing the Play/Pause button 3 seconds.

Charging

Plug the USB cable into the speaker connect to the 5V charger or computer to charge the speaker.
When charging, the “charging” red indicator light on when it is full the red light is out.

Other

The default volume of the speaker is 2/3 of the total volume .To protect battery life and speakers work, so the software Settings when the battery voltage is lower than 3.3 V speakers will automatically detect the concurrent give out sound prompt alarm, when battery voltage is lower than 3.3 V the speaker makes a voice prompt and set up automatic shutdown meantime.
When the speaker standstill, the speaker will power off automatically if not use the speaker 10 minutes. If need play again ,needs to power on the speaker again.