GAINSBOROUGH K202 Solar 3 Tier Bronze Water Feature Instruction Manual
- June 4, 2024
- GAINSBOROUGH
Table of Contents
Solar 3-Tier Bronze Water Feature
Instruction Manual
Dimensions
(H) 89 x (W) 51 x (D) 51cm
Length of lead: 3m
Size of solar panel: 20 x 17cm
- MONOCRYSTALLINE SILICON SOLAR PANEL 12V/4W
- WATERPUMP 9V – 170MA
- Power: 120V a.c.
- Water capacity: 3.78L
Battery: 1 x 7.4V 600mAh (not replaceable)
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from
the packaging
Parts
Before using the first time
Allow the panel to charge for at least 8 hours in full sunlight.
Find an ideal place for Solar Light.
Place the solar panel in an area where it will receive direct sunlight for at
least 8 hours per day. The number of hours the pump will work is directly
proportional to the hours of sunlight it receives. If the panel is placed in a
shaded area, it will not be able to fully charge and its pumping time will be
limited.
Assembly
Place the fountain base on a smooth level surface. Attach the pos connector to the fountain base. Screw post into the post connector by twisting it clockwise with the threads. sure that the post and the post connector are snugs.
Fit the pump (attached to the fountain basin) into the pump housing on the side with the gap. (Note: The pump cord fits into the gap).
Insert the pump housing pipe into the hole on top of the pump. Rotate the nut and washer on the pipe until they are tight at the top of the pump housing. Ensure that the rectangular guide is flush with the raised areas. The bottom of the pump should be flat against the base of the ump housing.
Locate the pump power cable and feed it through the top of the post. Pull the pump power cable out of the hole under the fountain base then connect the solar panel.
Attach the fountain basin by twisting it onto the post. Ensure it is level before proceeding. Place the washers on the holes of the fountain basin. Run the cord through the gap of the pump housing. Align the holes of the pump housing and the holes of the fountain basin and washers and tighten the screws.
Place the pump cover around the pump housing. Place the lower tier on the pump
housing pipe and press down until it fits into the top of the pump cover hole.
Place the dish cover on the pump housing pipe followed by the pper tier
followed by screwing on the top piece.
Fill The fountain basin with 1 gallon of water, being careful not to overflow
and cause splashing. Make sure the water completely submerges the pump.It is
recommended you use distilled water to prevent scale build-up. The first time
you operate the pump it can take up to 5 minutes for the air to be completely
expelled and water begins to flow properly. Plug the pump power cable into
your power supply and water will start flowing.
Care and Maintenance Recommendations
- Clean solar panel with a soft sponge every couple of weeks.
- Make sure all connectors are still tight and no water getting in.
- Keep the water clean during the summer keep topping up every 3 or 4 days with clean water.
- Clean any pipes every month to stop any build-up of algae that could put extra pressure on your pump.
- Take out any foreign body around the pump and keep the clean solar products.
- Always make sure there is enough water for the pump to work otherwise you could damage the pump.
- Make sure you clean the pump on a regular bases when you are cleaning face the solar panel face down on a towel this will stop the pump from running or switch it off.
- During the winter if you can bring it inside and give a good clean ready for next year.
BATTERIES
- Keep batteries away from children and pets.
- Never dispose of batteries in a fire.
- Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance with local regulations. For detailed information, contact your local authority.
- Follow the battery manufacturer’s safety, usage, and disposal instructions.
DISPOSAL
- Coopers of Stortford use recyclable or recycled packaging where possible.
- Please dispose of all packaging, paper, cartons, and packaging in accordance with your local recycling regulations.
- Plastics, polybags – these is made from the following recyclable plastic.
Code & Symbol|
---|---
Type of Plastic| Polypropylene
Commonly used for| Microwaveable food containers, yogurt pots, butter tubs,
disposable plates and cups
Notes| Commonly recycled and collected from household recycling bins
(packaging tape itself not recyclable but does not interfere with cardboard)
- At the end of the product’s lifespan please check with your local council-authorized household waste recycling center for disposal.
Calls cost 7 pence per minute plus your telephone company’s network access charge
The Enterprise Department Head Office:
11 Bridge Street
Bishop’s Stortford, CM23 2JU
Tel: 0844 482 4400*
Fax: 01279 756 595
www.coopersofstortford.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>