Dysaim D1J830ShO4L Gesture Sensing RC Stunt Car Instruction Manual
- June 12, 2024
- Dysaim
Table of Contents
WATCH REMOTE CONTROL
Functions Of Switch Keys: 1.Press once to turn on, the body light is
always on, then it is induction mode 2.Press again, the body light will flash,
then it is dodge mode 3.Press again to turn off sensing mode Long press to
shut down.
Function of the watch: All four light are on, go forward/backward/turn
left/turn right Lean 45° to the left–Left horizontal line Lean 45° to the
right–Right horizontal line Lean 60° to the left–Left rotation Lean 60° to the
right–Right rotation Four indicator lights flash, snake forward/backward/left
sidle /right sidle Two indicator lights flash, transform Press the switch
button one time, close the light, long press for Power off
When the 3.7V battery is charged, the charging line light is red, and when it
is full, the red light goes out 3.7V1
WATCH REMOTE CONTROL OPERATION DIAGARM
Press the button to enable the twist mode
When the car is not operated for 50 seconds, the car will automatically enter
the sleep state. Wait for the next remote control to turn off the car switch
and then turn it on again.
The small buttons twist upward
Buttons Small buttons down in parallel
2.4G AUTOMATIC CODE INSTRUCTIONS
-
After put the batteries in the remote control, the indicate light flashing,and put the batteries in the car and set it on,starting to contect it,if success, the controller indicate light off. Note:Ortherwise repeat the above operation.
-
Each remote control can only be connected with a remote control car, when the connection is successful, each car does not interfere with each other.
Note: not many cars connected at the same time. -
After one minute. The remote controll did not find the 2.4g signal from the remote control vehicle, the power indicator flashed, and the power switch should be restarted to frequency.
-
When you need to pair with other models with remote control or remote control car, you nred to turn off the remote control and remote control car power can be re-paired.
The remote control does not have a successful code blinking indicator, the good code indicator does not light up
HOW TO INSTALL THE BATTERY
The Remote Control
- Open the battery cover of teh remote control and load the 2X1.5V AA batteriesaccording to the indication of the positive and negative poles of the remote control battery compartment.
- Close teh battery cover.
PACKING LIST
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>