MAHLE eShifters Assistance Controller User Manual
- June 4, 2024
- MAHLE
Table of Contents
MAHLE eShifters Assistance Controller
CONTENT
- 1x Y-joint
- 2x eShifters (either 720 or 970)
- 2x Silicon bands
ASSEMBLY
INTRODUCTION
- Contact the place of purchase or a bicycle dealer for information on installation and adjustment of the products which are not found in the user’s manual.
- Do not disassemble or alter this product.
- These are small waterproof connectors. Do not repeat connecting and disconnecting it. It may impair the function.
- The components are designed to be fully waterproofed to withstand wet weather riding conditions; however, do not deliberately place them into water.
- Do not clean the bicycle in a high-pressure car wash. If water gets into any of the components, operating problems or rusting may result.
- Do not use thinners or similar substances to clean the products. Such substances may damage the surfaces.
- Be careful not to let water get into the terminal.
- Products are not guaranteed against natural wear and deterioration from normal use and aging.
INSTALLATION STEPS
- Check all contents of the box are available.
- Uninstalling the iWOC ONE is required, for more information contact the place of purchase or a bicycle dealer.
Warning : Ensure the system is OFF during all installation process.
- Overall overview of the assembly
- Install each eShifter in the desired position (several options may be available).
- The connection to the Y-joint must follow the following scheme:
- Left eShifter connected to labeled Y-joint part.
- Right eShifter connected to the other output.
- Connect Y-joint to iWoc ONE.
- Turn ON the system and check the functionality
- Assembly back again iWoc ONE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>