Aimpire WPD030 Multi-Functional Wireless Power Bank User Manual

October 30, 2023
Aimpire

Aimpire - logo WPD030 Multi-Functional Wireless Power Bank
User ManualAimpire WPD030 Multi Functional Wireless Power
Bank

CWPD309
Please Read The Manual Carefully Before Use.

Power Bank Parameters

Aimpire WPD030 Multi Functional Wireless Power Bank -
fig
Model: WPD30

  1. AC Input: 100-240V AC, 50/60Hz. 03A Max
    Total Output 5V/2A Max. USB-A Output 5V/2A Max
    Type-C Cable Output: 5V/2A Max

  2. Battery: 3.7V/15000mAh, 55,5Wh.

Type-C Cable Input: 5V/3A, 9V/2A; 18W Max
Total Output: 5V/3A Max.
Type-C Output: 5V/3A Max Type-C
Cable Output: 5V/3A 9V/2.33/1/412V/1.7A; 21W Max
USB-A Output: 4.5V/5A 5V/3A, 9V/2A. 12V/1.5A; 225W Max
Wireless Charger Output: 15W Max.
Weight: 266g Dimension : 127•59.5’30mm Aimpire WPD030 Multi Functional
Wireless Power Bank - fig1

The digital screen lights on when the power bank starts to charge. The digital screen shows the number of actual power percentage from 0% — 100%.

Mobile Power Usage Function

Aimpire WPD030 Multi Functional Wireless Power Bank -
fig2
Aimpire WPD030 Multi Functional Wireless Power Bank -
fig3If the power bank is charging, the LED screen will start to flash and show the power capacity percentage. The LED light stop flash when it is fully charge with 100% power capacity.

Important Safety Instructions

When using this product, basic precautions should always be followed, When using this product, basic precautions should always be followed, including the following: including the following:

  1. Store product in a cool and dry place.
  2. Do not store the product in hot or humid environments.
  3. Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
  4. Operating temperature should be between 32°F to 104°F / 0 C to 40 C.
  5. Do not disassemble the product Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
  6. If the product is not used for long periods of time, you should change and discharge once every three months.
  7. When charging a device, the product may feel warm, this is a normal operating condition and should not be cause for concern.
  8. In normal conditions, the battery performance will decline over several years.
  9. Do not dispose of the product in heat or fire.
  10. Do not clean the product with harmful chemicals or detergents.
  11. Misuse, dropping, or excessive force may cause product damage.
  12. When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
  13. Be aware discharged battery may cause fire or smoke, tape the terminals to insulate them.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals