NATIONAL GEOGRAPHIC 9070210 Tempy Thermo Hygrometer Instruction Manual

NATIONAL GEOGRAPHIC 9070210 Tempy Thermo Hygrometer

MANUAL DOWNLOAD

www.bresser.de/P9070210

SERVICE AND WARRANTY

www.bresser.de/warranty_terms

GENERAL WARNINGS

RISK OF CHOKING!
Keep packaging material, like plastic bags and rubber bands, out of the reach of children, as these materials pose a choking hazard.

RISK of ELECTRIC SHOCK!
This device contains electronic components that operate via a power source (Batteries). Only use the device as described in the manual; otherwise, you run the risk of an electric shock.

RISK of FIRE/EXPLOSION!
Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into a fire. Excessive heat or improper handling could trigger a short-circuit, a fire or an explosion.

RISK of property damage!
Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary

NOTE!
Do not immerse the unit in water. Do not subject the unit to excessive force, shock, dust, extreme temperature or high humidity, which may result in malfunction, shorter electronic life span, damaged batteries and distorted parts.

NOTE!
Use only the recommended batteries. Always replace weak or empty batteries with a new, complete set of batteries at full capacity. Do not use batteries from different brands or with different capacities. Remove the batteries from the unit if it has not been used for a long time.

NOTE!
The manufacturer is not liable for damage related to improperly installed batteries!

EC DECLARATION OF CONFORMITY

Hereby, Bresser GmbH declares that the equipment type with part number: 9070210 is in compliance with Directive: 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.bresser.de/download/9070210/CE/9070210_CE.pdf

UKCA Declaration of Conformity
Bresser GmbH has issued a „Declaration of Conformity“ in accordance with applicable guidelines and corresponding standards. The full text of the UKCA declaration of conformity is available at the following internet address: www.bresser.de/download/9070210/UKCA/9070210_UKCA.pdf

CLEANING AND MAINTENANCE

Before cleaning the device, disconnect it from the power supply (remove batteries)! Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid.

DISPOSAL
Dispose of the packaging materials properly, according to their type, such as paper or cardboard. Contact your local waste-disposal service or environmental authority for information on the proper disposal. Do not dispose of electronic devices in the household garbage! As per Directive 2012/19/EU of the European Parliament on waste electrical and electronic equipment and its adaptation into German law, used electronic devices must be collected separately and recycled in an environmentally friendly manner

SCOPE OF DELIVERY

Thermo/Hygro station, instruction manual, button cell battery (3.0V, type CR2032)

PARTS OVERVIEW

1. Display
2. (a) Indoor temperature
3. (b) Indoor humidity
4. (c) Comfort level
5. Wall-mount recessed hole This hole makes it possible to mount the Thermo/Hygro station on a wall. Thanks to its magnetic back, the Thermo/Hygro station can also be attached to metal surfaces without screws.
6. Battery compartment for 1x CR2032
7. Table stand Add if station is to be placed on a flat surface.

POWER SUPPLY

1. Open the battery compartment door.
2. First use : remove the tranparent plastic tab. Battery change: Use only a CR2032 (3.0V) type battery and insert it according to the polarities (+/-) shown.
3. Reinsert the battery compartment door.

OPERATION

Temperature and humidity

1. Once the battery is installed, the Thermo/Hygro station will start displaying the interior measurement information.
2. There are 3 different icons to displaying the indoor climate as below:

Comfort level

1. humidity is lower than 40%; at the same time, the temperature is higher than 20°C, but lower than 27°C.
2. humidity is higher than 70%, or temperature is lower than 20°C, or temperature is higher than 27°C.
3. humidity is between 40%-70%, at the same time, the temperature is higher than 20°C, but lower than 27°C.

SPECIFICATIONS

Measurement

• Indoor temperature range : 0-50 °C
• Temperature tolerance : ± 1 °C
• Humidity range : 10-99%
• Humidity tolerance : ± 5%

Power supply
1x CR2032 (3.0V button cell)

WARRANTY & SERVICE

The regular warranty period is 2 years and begins on the day of purchase. To benefit from an extended voluntary warranty period as stated on the gift box, registration on our website is required. You can consult the full warranty terms as well as information on extending the warranty period and details of our services at www.bresser.de/warranty_terms.

Every purchase helps support the global nonprofit National Geographic Society in its work to protect and illuminate our world through exploration, research, and education. TO LEARN MORE, VISIT NATGEO.COM/INFO

© National Geographic Partners LLC. All rights reserved. NATIONAL GEOGRAPHIC and Yellow Border Design are trademarks of National Geographic Society, used under license. Visit our website: www.nationalgeographic.com Errors and technical changes reserved.

Bresser GmbH Gutenbergstr. 2 46414 Rhede Germany

• www.bresser.de
• info@bresser.de

Bresser UK Ltd. Suite 3G, Eden House Enterprise Way, Edenbridge, Kent TN8 6HF, Great Britain Manual_9070210_Thermo-Hygro-Set-Tempy_de-en-fr-nl-it- es_NATGEO_v032023a

References

• Bresser | Startseite | Expand Your Horizon mit BRESSER
• bresser.de/garantiebedingungen
• Bresser | NATIONAL GEOGRAPHIC Thermo-/Hygrometer Tempy 4er-Set | Expand Your Horizon
• bresser.de/warranty_terms
• National Geographic

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>