Britex PTS Toilet Suite Instructions
- October 30, 2023
- BRITEX
Table of Contents
Britex PTS Toilet Suite
Toilet Suite
The Britex Toilet Suite is a modern, sleek design that features a P Trap of
L06721 and an S Trap of L06720. It has a PTS of 650 and dimensions of
150x430x430mm. The product comes with access panels to both sides with tamper-
resistant screws, and an optional S Trap is available. The S Trap convertor
125 supplied with the product is Plastec (S Trap) #11510 Pan Bend. The Floor
Fixing Bracket is an integral part of this toilet suite.
Product Usage Instructions
The Britex Toilet Suite should be anchored to the floor using the offset bracket supplied with the product. The pan should be secured to the rear wall using four fixing holes integral to the pan body. Four pieces of 12mm diameter threaded rods with nuts and washers (not supplied) are recommended to fix the pan to the wall. The concealed fixings can be accessed by removing panels on the sides of the toilet pan. The access panel screws are hex head type only. After installation is completed, the pan should be sealed around the perimeter. A mini-stop can be installed on the rear wall within the confines of the suite at approximately 250mm above FFL and 100mm from the center of pan outlet, then connection from mini-stop to 15mm cistern inlet by flexible connector. The toilet seat is not fitted as standard. If required, please advise. Please refer to page 60 for seat details. The OD Outlet measures 100mm and the inlet is 1/2 inch. The installation notes can be viewed by scanning the QR code provided with the product.
Note that due to ongoing research and our commitment to product development, details are subject to change without notice. Details accurate at time of print.
Scan QR code to view our installation notes
To order this item please advise:
- PTSGP = Grandeur Pan, P Trap
- PTSGS = Grandeur Pan, S Trap
- PTSCP = Centurion Pan, P Trap
- PTSCS = Centurion Pan, S Trap
NB: Seat not fitted as standard.
If required, please advise. Please refer to pg 60 for seat details.
Product Info
- Highly vandal resistant
- Supplied pre-plumbed (cistern to pan)
- Available with Grandeur or Centurion pan
- Safety radius front edge on pan
- Double-skinned, tamper-resistant cistern casing
- Available with added seat (see pg 60 for options)
INSTALLATION NOTES
- Pan is anchored to floor with an offset bracket (supplied).
- Pan is secured to rear wall via 4 fixing holes integral to pan body.
- Suggested fixings required for fixing to wall are 4pcs of 12mm dia. threaded rods with nuts and washers (not supplied).
- Concealed fixings can be accessed by removing panels on sides of toilet pan.
- Access panel screws are hex head type only
- Pan should be sealed around perimeter after installation is completed.
- A mini-stop can be installed on rear wall within the confines of the suite at approx.
- 250mm above FFL and 100mm from centre of pan outlet, then connection from mini-stop to 15mm cistern inlet by flexible connector.
TOILETS
TOILET SUITE
Please refer to britex.com.au for the most current product information Allow
+/- 5mm tolerance for dimensions and setouts shown in product literature.
Due to ongoing research and our commitment to product development, details are
subject to change without notice. Details accurate at time of print
britex.com.au |
info@britex.com.au | A.B.N 83 004 309 737