MULTINAUTIC 15012 Straight Wide Quick Release Aluminum Dock Ladder Installation Guide
- October 30, 2023
- MULTINAUTIC
Table of Contents
STRAIGHT ALUMINUM LADDER
ASSEMBLY AND INSTALLATION GUIDE
(for ladder models : 15012-15013-15094)
BOX CONTENT
REQUIRED TOOLS
3/8’’ wrench
Screwdrivers
– Phillips-headed #2
– Square #2
Cordless drill for reinforcement wood pieces
-
STEP ASSEMBLY
Install the steps with the #8 x 2″ screws starting with the top step and tighten very lightly. When installing the steps, you must start with the TOP one. However, if the alignment is not exact, GENTLY align the ladder upright with the screw and lightly tighten. You must install all steps and then finish tightening. DO NOT OVERTIGHTEN. Add the 4 plastic end caps in the uprights. -
“J” HOOKS
Install the “J” hooks on the ladder with the four 1 1/2″ bolts and nuts in the handrail holes with a 3/8″ wrench. -
RETAINING LOOPS
Position the ladder on the dock, with the uprights against the dock when possible, place the footman loops in the “J” hooks and screw them partially into the decking (with an angle for a better grip in the wood) using the 2 ½” wood screws.
Remove the ladder to proceed with the next step. -
REINFORCEMENT WOOD PIECES
It is recommended to screw two 1 ½” thick wood pieces under the decking to ensure a solid grip on the footman loop screws and to spread the load over several boards. If you cannot access the underside of the dock, you can carefully remove a few planks from the decking to install these reinforcements.
This ladder has a 250 lbs capacity.
Should you encounter any difficulties with this product,
Suggested complementary product
do not return it to the store. Please contact our Customer Service.
Install this ladder at different locations on your dock according to your
activities by getting additional footman loops.
Product #32382 (1 pair)
The Best Customer Service Team is there for you !
1-800-585-1237
Live Chat Online | MULTINAUTIC.COM
ASSEMBLE – ENJOY – SHARE !