Smartlix D6255 Smart Door Lock Instruction Manual

D6255 Smart Door Lock
Instruction Manual

D6255 Smart Door Lock

Test whether the latch bolt rotate smoothly.

INSTALL THE INTERIOR ASSEMBLY AND BATTERY COVER

A Connect the cable and ensure connection is tight. Then install interior assembly with three screws (J) provided.
IMPORTANT: Please make sure the knob is in vertical position, and the latch bolt is fully retracted(in the unlocked position) before installation.
B . Load 4 batteries and install the battery cover.
C Finish Installation.

Programming Instructions

1. MASTER CODE (4 to 10 digits)
   The default Master Code is 12345678. It is required that you change it to a code of your own before programming.

2. USER CODE (4 to 10 digits)
   A total of 20 User Codes (and one temporary one-time User Code) may be programmed

3. SETTING RULES
   Both master and user codes don’t support the following combination of numbers.

Definitions

1. MASTER CODE
   a.Required for programming and feature settings. Master code can be used to unlock the door under vacation mode.
   The default master code needs to be changed before programming.
   Property owner/manager should keep this information confidential.

2. AUTO LOCK
   a.Lock the deadbolt automatically 30 seconds after unlocking.
   b.Press and hold any keypad for more than 2 seconds to lock the deadbolt automatically.

3. WRONG ENTRY LIMIT
   After 10 unsuccessful attempts at entering a valid pin code, the unit will shut down for 3 minutes, the keypad light will be off at the same time, there will be one-second sound while pressing any keys.

4. SILENT MODE
   The beep sounds can be muted when pressing keypad. But you will still hear the alerts of low battery and system prompt.

5. VACATION MODE
   This is a security feature for you when you are leaving your home for vacation or long trip. Enabling vacation mode will restrict all user codes until master code is entered on keypad. Inputting any User Code causes one beep. Inputting wrong Master Code causes 2 beeps.

6. ANTI-PEEPING FUNCTION
   User can prevent pin code exposure to strangers by entering random digits before the pin code.
   37291…………………….. Random digits
   31684………………….. password

Parts Illustrations

Exterior AssemblyInterior Assembly
** The default Master Code is 12345678.It is required that you change it to a code of your own before programming.
**

Quick Set Up

**** The default Master Code is 12345678. It is required that you change it to a code of your own before programming.

• Every press in 10 seconds.
• 3 beeps appear at every wrong and overtime step. Then you will exit programming mode.
• 1.5 seconds continuous ring means you can go on until succeed.
• If see all keypads light constantly, please press random keypad to finish programming.
• One-time Code (8) will be invalid if you enable Vacation Mode (7).
• note: is the Multi-Function button in Exterior Assembly.

Factory Default Settings

Restore To Factory Default Settings

The default Master Code is 12345678.It is required that you change it to a code of your own before programming.

1. Open and unlock the door.
2. Take out one battery, then press random keypad to consume the rest power.
3. Press the Reset Button with the Reset tool (K), then keep pressing and place the battery back.
4. Keep holding the Reset Button until you hear 2 beeps. (If just hear one beep, please do it again from step 1)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>