Lepro 350011-NW-US 240W Dimmable UFO LED High Bay Light User Manual

Table of Contents

350011-NW-US 240W Dimmable UFO LED High Bay Light
User Manual

Model No.: 350009-NW-US, 350010-NW-US, 350011-NW-US

Do not use an electric generator to test the LED light.
Please abide by the related country, regional and local laws and regulations when installing this ﬁxture.
Turn off the power before installation or maintenance.
Proper grounding is required to ensure safety.

Notice:

To avoid the possibility of an electric shock or ﬁre, the installation personnel must have professional electrical knowledge.
Please wear gloves to avoid injury before installation.
If there is any smoke or spark, turn off the power immediately and consult a qualiﬁed electrician.
Please use water-proof strain-relief bushing when connecting the supply cord to the outlet box.

Attention:

Please check if there is any damage during shipping. If so, contact the manufacturer in a timely manner.
Please read the installation instruction carefully to check whether all the accessories are complete. After conﬁrmation, install the ﬁxture according to the installation steps.

This LED high bay light has a 0-10v dimming function, and can also be equipped with an optional DC motion sensor (not included).

Hook Mount, Ceiling Mount, 1/2″NPT Mount.
(Please choose the most suitable installation method for the purchased product according to your needs)

Hook Mount:

Screw the hook into the ﬁxture, tighten and ﬁx it.
Hang the ﬁxture on the ceiling hook or chain.
After installation, connect the wire of the ﬁxture to the mains according to local wiring rules, ensuring the connection is stable and protected.

Ceiling Mount: (accessories are not included, please contact us if you need them)

Mark with a marker pen or sharpie tool onto the mounting surface and drill.
Fix the screws into the holes with a hammer.
Align the bracket hole with the screw hole, push the ﬁxture to one side, and ﬁx it.
After installation, connect the wire of the ﬁxture to the mains according to local wiring rules, ensuring the connection is stable and protected. By adjusting the brackets and screws, users can adjust it 50° to the left or right vertically.

1/2″ NPT Mount: (accessories are not included, please contact us if you need them)

Unscrew the nuts on the 1/2″ NTP.
Insert the 1/2″ NTP stem into the bracket hole.
Re-screw the nuts.
After installation, connect the wire of the ﬁxture to the mains according to local wiring rules, ensuring the connection is stable and protected. By adjusting the brackets and screws, users can adjust it 50° to the left or right vertically.

Installation of DC motion sensor: (accessories are not included, please contact us if you need them)

With the 1/2 NPT interface, it’s possible to realize the replacement of different functional devices according to your needs by using a screwdriver. See the schematic diagram for details;
The ﬁxture comes with a 1/2 plug by default. Motion sensors and PIR sensors are optional accessories. Choose which one to use according to your needs;
Default programs have been set for the motion sensor and PIR before shipment. They need to be reset by remote control if you need to change the working mode. The remote control is also an optional accessory.

LEPRO INNOVATION INC
3651 Lindell Road Suite D1048,
Las Vegas, NV 89103, USA
www.lepro.com
+1 866-287-2558
cs@lepro.com
Le Ming Trading Inc.
801-6081 No.
3 Rd. Richmond, BC, V6Y 2B2, CA
www.lepro.ca
+1 833-433-1453
cs@lepro.ca
Made in China Fabriqué en Chine