realwear Navigator 500 Ultimate Hands-Free Wearable for Industrial Workers User Guide
- October 30, 2023
- realwear
Table of Contents
RealWear Navigator 500
Quick Start Guide
Navigator 500 Ultimate Hands-Free Wearable for Industrial Workers
ATTENTION: Before using the Navigator 500 for the first time, visit
https://www.realwear.at/en/support from another device (phone or computer).
Front View
Rear View
Switching on and Adjusting **
**
Adjust camera position by rotating up / down for the best view
Adjust the Display so you can see all 4 corners of the display
and then lock it intoposition using the locking ring
Setting up the Display
Adjust the workband so that the Nav500 rests horizontally, and the display
slightly below the line of sight
Position the boom arm and elbow joints into a “Z”
shape, below the line of sight, left or right eye.
Do not extend the display too far from your eye.
Keep the display as close to the eye as possible for the best view.
NOTE: Your Navigator 500 is shipped partially charged from the factory.
If the battery level is too low, please see charging instructions below.
Voice Input
The Navigator 500 is controlled simply by using your voice and
head motion. Speak out clearly, say what you can see on the screen. Just say
the name of the icon you want to open. To use the bubbles 1 with numbers, just
say “select item 1”.
Charging the Navigator 500
Charging the Navigator 500
- Connect the USB-C charging cable to the USB-C port located under the rear cover on the same side as the boom arm.
- Connect the charging cable to the wall charger and plug the charger into a wall socket. The power button lights up ORANGE while charging. The Power button will light up GREEN, once it reached 90% battery status.
Rechargeable Battery
Workband
Barcotec Support Contact
E-Mail: support@barcotec.at
Phone: +43 1 786 39 40
Barcotec GmbH, Julius Welser Straße 15
5020 Salzburg
https://www.realwear.at/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>