TAFFIO NTG 2.5 Quadlock Adaptor Cable Installation Guide
- October 30, 2023
- TAFFIO
Table of Contents
TAFFIO NTG 2.5 Quad lock Adaptor Cable
Product Information
The product is a portable speaker that connects to devices via Bluetooth technology. It has a rechargeable battery that provides up to 8 hours of playtime. The speaker is equipped with a built-in microphone for hands-free calling and voice assistant access. It also has a 3.5mm audio jack for non- Bluetooth devices.
Product Features
- Bluetooth connectivity
- Rechargeable battery (up to 8 hours playtime)
- Built-in microphone for hands-free calling and voice assistant access
- 3.5mm audio jack
- Portable design
Usage Instructions
To use the portable speaker, first ensure that the speaker is fully charged.
The charging time may vary depending on the remaining battery level. Once
fully charged, turn on the speaker by pressing and holding the power button
until the LED light turns on. The speaker will automatically enter pairing
mode. To connect your device, enable Bluetooth on your device and search for
available Bluetooth devices. Select the speaker from the list of available
devices and pair the devices by following the on-screen instructions. If your
device does not support Bluetooth or you prefer to use a wired connection, you
can use the 3.5mm audio jack on the speaker to connect to your device using an
audio cable. To answer calls, press the answer button on the speaker when
receiving a call. To end a call, press the same button again. To activate
voice assistant, press and hold the answer button until the voice assistant
activates. To turn off the speaker, press and hold the power button until the
LED light turns off.
The amplifier is located behind the driver’s seat in the footwell or on the
driver’s side in the boot. Unplug the connector here and connect to the
supplied connector as shown in the picture below. Connect the blue cable
(radio antenna) to 12V+.