GivEnergy Giv-Bat 9.5 Gen 2 Lithium Iron Phosphate Battery Instruction Manual

October 30, 2023
GivEnergy

GivEnergy Giv-Bat 9.5 Gen 2 Lithium Iron Phosphate Battery Instruction

Manual

GivEnergy Giv-Bat 9.5 Gen 2 Lithium Iron Phosphate
Battery.jpg

SPECIFICATIONS

GivEnergy Giv-Bat 9.5 Gen 2 Lithium Iron Phosphate
Battery.jpg

BIGGER AND BETTER

Increased storage and efficiency

The 9.5kWh battery pack sits alongside our AC Coupled or Hybrid Inverter so that you can store energy from the grid or excess generation.

Utilising lithium iron phosphate, our batteries are extremely safe and can be installed in a wide range of locations. Our battery warranty means you can use your battery as much as you need for 10 years and still be covered.

FIG 1 Specifications.JPG

BOX CONTENTS

FIG 2 BOX CONTENTS.JPG

FIG 3 BOX CONTENTS.JPG

FIG 4 BOX CONTENTS.JPG

GENERAL INFORMATION

Introduction

All information contained in this booklet refers to the assembly, installation, commissioning, and maintenance of Generation 2 batteries. Please retain this manual for future reference. Legal Disclaimer: This document is the property of GivEnergy, reproduction is prohibited.

Installation Requirements
Installation of all GivEnergy equipment must be carried out by a GivEnergy approved installer.

Unit Information
The Generation 2 batteries are designed to work with a GivEnergy AC Coupled or Hybrid Inverter. The batteries work with renewable generation or import from the grid at off-peak times when prices are lower, and discharge during busier periods when prices are more expensive.

Storing the Battery
The units must be stored in their original packaging at temperatures between -30ºC – 60ºC. Please note that between -10ºC – 0ºC there may be reduced performance in charging and discharging. Do not stack more than 4 units on top of each other.

Packaging Contents
When unpacking, please check the following

  • There are no missing accessories from the packaging list
  • The model and specification of the battery’s nameplate match the order specifications

If any damaged or missing parts are found, please contact GivEnergy on 01377 252 874 or email support@givenergy.co.uk immediately. Returns must be provided in original or equivalent packaging. The cardboard packaging is recyclable.

COMPONENTS

FIG 5 COMPONENTS.JPG

FIG 6 COMPONENTS.JPG

BATTERY CABLES

Two types of cables exist for connection to Gen 2 batteries;

FIG 7 BATTERY CABLES.JPG

IMPORTANT
All Generation 2 battery cables need to be purchased seperately.

SAFETY AND INSTALLATION

Safety Instructions
Extra care and attention must be taken when installing and maintaining any GivEnergy equipment. The system is capable of lethal voltages, even when disconnected

  • If you suspect something is wrong with the battery, contact GivEnergy on 01377 252 874 or email support@givenergy.co.uk.
  • If any damaged or missing parts are found, please contact GivEnergy on 01377 252 874 or email support@givenergy.co.uk immediately. Returns must be provided in original or equivalent packaging. The cardboard packaging is recyclable.

Installation Instructions

  • All electrical installations must be carried out by a qualified and registered electrician and in accordance with the IEE Wiring Regulations
  • Ensure batteries are always fixed to the wall using the mounting bracket, even when the weight of the product is on the floor
  • All GivEnergy equipment must be installed by a GivEnergy approved installer
  • Externally mounted batteries must always be wall mounted above the frost-line or a minimum of 50mm
  • An earth bond must be installed between all batteries and inverters
  • Do not remove the front cover unless instructed by the GivEnergy support team

FIG 8 Installation Instructions.JPG

STEP-BY-STEP INSTALLATION

FIG 9 STEP-BY-STEP INSTALLATION.JPG

For Generation 1 Inverters only

FIG 11.JPG

For Generation 2 Inverters only

FIG 12.JPG

For Generation 3 Inverters only

FIG 13.JPG

For installing additional batteries

FIG 14.JPG

FIG 15.JPG

FIG 16.JPG

DIP SWITCHES AND STATUS INDICATORS

FIG 17 DIP SWITCHES AND STATUS INDICATORS.JPG

FIG 18 Status Indicators.JPG

FIG 19 What does the STATUS light mean..JPG

MANUFACTURER WARRANTIES

GivEnergy is the main supplier and manufacturer of the product. GivEnergy warrants that your product is (a) of acceptable quality and (b) does not have any latent defects.

  • If you suspect something is wrong with the battery, contact GivEnergy on 01377 252 874 or email support@givenergy.co.uk.
  • If any damaged or missing parts are found, please contact GivEnergy on 01377 252 874 or email support@givenergy.co.uk immediately. Returns must be provided in original or equivalent packaging. The cardboard packaging is recyclable.

Products Covered

FIG 20 Products Covered.JPG

www.givenergy.co.uk

Read More About This Manual & Download PDF:

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals