Globe Lighting 51395 Kingsbury 1-Light Black Outdoor Flush Mount Light Instruction Manual
- October 30, 2023
- Globe Lighting
Table of Contents
Globe Lighting 51395 Kingsbury 1-Light Black Outdoor Flush Mount Light
Instruction Manual
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
Parts
- **Fixture
**
- **Glass
**
- **Rubber washer
**
- **Mounting Unit
**
- **Mounting Screws
**
- **Wire Nuts
**
- **Cap Nuts
**
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
Assembly Instructions
STEP 1
Use the mounting screws to attach the mounting unit to the junction box
STEP 2
Make the electrical connection from the junction box to the fixture. Connect
the ground wire to the mounting unit using the preinstalled green ground
screw. Then, connect the positive, negative and ground wires with the supplied
wire nuts. Secure with electrical tape
Connect Clear, Brown, Gold or Black Parallel Wire without tracer (round &
smooth) or Black Fixture Wire to:
Black or Red Supply Wire or Insulated Wire (other than green) with copper
conductor.
Connect Clear, Brown, Gold or Black *Parallel Wire with tracer (square &
ridged) or White Fixture Wire to:
White Supply Wire or Insulated Wire (other than green) with silver conductor
STEP 3
Secure the fixture to the mounting unit with the cap nuts.
Install a bulb E26 60W MAX(not included).
Place the glass over the fixture and twist it clockwise until tightened.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>