PQ Lighting 84285 LED Tone Select Prestige Ceiling Light Instruction Manual
- June 4, 2024
- PQ Lighting
Table of Contents
PQ Lighting 84285 LED Tone Select Prestige Ceiling Light
INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED ELECTRICIAN. Read these
instructions carefully, and save them for a later date.
ALL ELECTRICAL CONNECTIONS MUST BE IN ACCORDANCE WITH LOCAL AND NATIONAL
ELECTRICAL CODE (N.E.C.) STANDARDS. IF YOU ARE UNFAMILIAR WITH PROPER
ELECTRICAL WIRING CONNECTIONS OBTAIN THE SERVICES OF A QUALIFIED ELECTRICIAN.
This device complies with Part 15 of the FCC rules and has been tested and
found to comply with the limits for a Class B digital device. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
WARNING-RISK OF FIRE OR ELECTRIC SHOCK
- Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/ or drawings
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
- No user-serviceable part inside. To avoid electrical shock do not disassemble the product
- To prevent early failure, fixtures should only be installed in operating environments ranging-4°F to 104’F (-20°C to 40°C)
- This product is not intended for use in emergency light fixtures or exits signs.
- For the latest list of compatible dimmers please visit our website.
- Use only on 120VAC, 60Hz circuits.
- Suitable for use in dry and damp locations.
- Covered ceiling mounts only.
WARNING-RISK OF ELECTRIC SHOCK
DISCONNECT POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING
THIS FIXTURE.
WARNING-RISK OF ELECTRIC SHOCK
DISCONNECT POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING
THIS FIXTURE
TOOLS NEEDED: Screwdriver, wire nuts, and electrical tape.
CEILING LIGHT INSTALLATION
-
Shut off power at the circuit breaker or fuse before installation.
-
If replacing an existing fixture, disconnect and remove the old fixture first.
-
Connect the fixture wires to the power supply wires using wire nuts; Black to Line, White to Neutral, and Green to Ground.
-
Align the canopy with the mounting screws holes on the junction b0x.
-
Thread the mounting screws through the keyhole slots in the canopy that align with the junction box mounting holes. Rotate the canopy until the screws
are at the small end of the keyhole slots. -
Ensure the wires are properly placed within the junction box. Tighten the mounting screws until the canopy is tightly seated against the ceiling.
-
Field adjustable CCT (Default: 2700K)-Select color temperature by sliding the CCI Selection Switch to the desired value.
-
Installthe diffuser;
- Item#: 84285 / 84288/ 84291- rotate diffuser until it securely locks into the canopy. (Fig. 1)
- ltem#: 84294 – install difuser, replace metal ring and tighten the decorative nuts onto the decorative bars. (Fig. 2)
PREMIUM QUALITY LIGHTING” www.PQLighting.com
P.QL., Inc, 2285 Ward Avenue Simi Valley, CA 93065
800-323-8107 Specifications subject to
change without notice. Photos and line drawings may not be to scale and are
for general reference only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>