Westbury BeBa 27490 Paintable Wooden Front Bath Panel Instruction Manual
- October 30, 2023
- Westbury
Table of Contents
BeBa 27490 Paintable Wooden Front Bath Panel
Product Information: Bath Panel Fixing
The Bath Panel Fixing is a product used to secure bath panels to the wall. It is manufactured in the UK using quality panels. The product comes with a 2-year guarantee.
Tools Required for Installation
- Spirit level
- Screwdriver
- Tape measure
- Pencil
- Fine toothed saw
- Utility knife
Additionally, you will require a piece of timber and some wooden rebated blocks. These items are not supplied with the product.
Installation Instructions
- Check the size of the bath panel and ensure it fits properly.
- Trim the universal end panel using a sharp knife if necessary. Trim only at the wall side.
- Set both panels vertically and ensure the end panel is located behind the front panel at the corner joint.
- To secure the panel to the wall, use a piece of timber and some rebated blocks set equal distances apart.
- Small mirror screws can be used to secure the panel against the timber. Alternatively, Velcro or Magnetic strips can be used to secure it neatly.
Please note that no claims will be accepted once the installation is complete. The image shown in the manual is for illustrative purposes only.
Bath Panel Fixing Installation Instructions
Before you start
- Before fixing panel remove All protective covering and examine carefully. The polythene film must be removed in fulland the panel checked for any visible damage.
- Unpack and check the product is complete and undamaged.
- Have the correct tools available.
Disclaimer
- Prior to fitting your panel, carefully remove all the packaging and film from the panel and examine the bath for damage and suitability of colour match
- Check the panel fit and match prior to installation.
Any refixing costs or claims for wrong color match, and/or any other faults will not be accepted after fixing
No claims for the above will be accepted once the panel is fitted
Tools required – not supplied
You will also require a piece of timber and some wooden rebated blocks
Trimming the universal end panel
To create a 700 or 750 finish, trim the end panel to suit at the wall side
using a small fine toothed saw or sharp knife.
It is recommended that sizes are checked prior to cutting and fitting to prevent mistakes from occuring.
Please note image shown opposite is for illustrative purposes only.
Panel fitting instructions
Should the cutting of panels be necessary (due to water pipes or skirting boards) a small fine toothed saw or sharp knife is recommended.
- A. Fit both panels in position, locate top flanges of the panels between bath frame and rim of bath.
- B. Ensure that both panels are set vertical and that the end panel is located behind the front panel at corner joint.
- C. secure the panel to the wall use a piece of timber secured to the wall vertically. For the floor we recommend some rebated blocks set equal distances apart.
- D. Small mirror screws can be used to secure the panel against the timber. Alternatively Velcro or Magnetic strips will secure in a neat fashion.
Illustrations and specifications are for reference only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>