WESTBURY HDTWH73377 ScreenRail Crossover Post Instruction Manual
- October 30, 2023
- Westbury
Table of Contents
WESTBURY HDTWH73377 ScreenRail Crossover Post Instruction Manual
- These instructions must be followed exactly as written and the materials used must be exactly as shown in the instructions. Any deviation from the instructions or variation in the materials used/installed may result in an unsuccessful installation.
- Tools Recommended: Hammer, Tape Measure, Miter Saw (with aluminum cutting blade), Screw Gun (with #2 square drive bit), Drill (with 3/16″ bit), Level, Non-scuffing Mallet or Wood Block.
SCREENRAIL CROSSOVER POST
ScreenRail Crossover Post Includes:
(1) ScreenRail Crossover Post 36″ or 42″ tall,
(1) 2-pack Modified Rail Mounts with covers and screws.
Step 1:
Determine spacing of ScreenRail CO Post between vertical members. ScreenRail
CO Post must be aligned with vertical members for a straight run on horizontal
rails.
Step 2:
Screen retention grooves must always be on the side the screen is to be
attached. (NOTE: Install all vertical posts and rails prior to installing
horizontal rails.)
Step 3:
Attach ScreenRail CO Post (Illustration CO1) with appropriate fasteners for
the surface to be attached to, (concrete anchors, TapCons, etc.). (Note: Use
fasteners on both sides of ScreenRail CO Post mount plate).
Step 4:
Cut horizontal rails to desired length. (Illustration CO2.)
Option A: Surface Mount Bottom Rails
Cut the bottom rails to the exact length between vertical rails and ScreenRail
CO Post positioned in previous steps. Attach bottom rails with appropriate
stainless steel fasteners 16″ on center.
Option B: Rail Mounts
Cut the top rails, (and bottom rails if using Option B), 1/4″ shorter per
mount (total 1/2″ for 2 mounts) than the distance measured between the
vertical rails and ScreenRail CO Post. Attach top rails to modified rail
mounts (included with ScreenRail CO Post) and bottom rails to rail mount
included with ScreenRail sections.
Step 5:
Attach top rail with #8 x 3/4″ stainless steel self-tapping screws (provided)
through the rail mounts.
Step 6:
Install the mount covers over the screws. (Hint: Place one side of the cover
so the retaining notch is in the lock position. Place a block of wood against
the side of the cover that is not locked. Tap gently to snap the cover in
place. Note: Instead of a wood block, a rubber or other non-scuffing mallet
may be used.) (Illustration CO3.)
Contact from where you purchased for questions
diggerspecialties.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>