CURT 45908 Adjustable Pintle Hitch Combination 2 Inch Receiver Installation Guide
- June 4, 2024
- Curt
Table of Contents
INSTALLATION MANUAL
45908
Level of Difficulty
Easy
Parts List
| 1 | Channel-mount |
|---|---|
| 1 | Pintle head |
| 1 | Hitch pin & clip |
| 2 | Channel-mount pin & clip |
| 1 | Anti-rattle set screw |
Step 1
Insert the adjustable channel mount into the trailer hitch of the vehicle and
secure it with the provided hitch pin & clip. Always secure the hitch pin with
a clip unless a locking
the device is being used.
Product Photo
Step 2
Insert the pintle head into the channel mount and raise or lower it to the
desired height. Insert the supplied pins through the holes that line up with
the holes in the channel mount and secure them with the provided clips.
Note: The supplied pins are specifically engineered for the channel-mount
system. If replacement pins are needed, they must be replaced with original
factory channel mount
pins (CURT# 45925).
Step 3
Insert the anti-rattle set screw and tighten to eliminate noise.
Note: Use of the set screw is not needed for safety; only to eliminate
possible rattle between the channel-mount and pintle.
Notes
Before you begin the installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time
required.
Before towing, ensure all pins & clips are secured.
Do not overload any part of your towing system.
See the vehicle owner’s manual to determine the vehicle tow rating.
WARNINGS
Never exceed the vehicle manufacturer’s recommended towing capacity. The
ratings of the channel-mount system are intended to represent the capability
of the product and in no way reflect the ratings or capacity of the towing
system it is being used with. The consumer or operator are strongly advised to
learn the ratings of the various components of the towing system and never
exceed the limits of the lowest rated component being used. Use of any pin
other than that of the channel-mount system manufacturer could be a serious
safety hazard and will void the warranty. Never hook up trailer safety chains
to the channel-mount system. Ensure the safety chains operate freely around
the channel-mount system and do not become entangled.
CURTMFG.COM
• NEED ASSISTANCE? • 877.287.8634• 45908-INS-RA • PAGE 1
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>