CURT 56325 Custom Wiring Connector Instruction Manual
- June 4, 2024
- Curt
Table of Contents
INSTALLATION INSTRUCTIONS
WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER
56325 APPLICATIONS
| Make | Model |
|---|---|
| Cadillac | XT5 |
| GMC | Acadia (excluding Limited) |
CUSTOM WIRING CONNECTOR
WIRING LOCATION GUIDE
SUVS, MINI & FULL-SIZED VANS (S)
The representative vehicle is shown below S6 – Behind the center of the rear
bumper
NOTICE
All steps must be followed to ensure the CURT wiring connector will function
properly. Once installed test for proper function by using a test light or
connecting a properly wired trailer.
All connections must be complete for the wiring harness to function. Test and
verify the installation of product with test light or trailer after
installment. For the initial test, reset the electrical system of the vehicle
by temporarily removing the vehicle’s key from the ignition.
TOOLS NEEDED
Wire cutter
Exceeding the product rating can cause loss of warranty, overheating, and potential fire. Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
Signal Circuits – 7.5 amps per side Tail / Running Circuits – 7.5 amps total Check the vehicle owner’s manual or contact the vehicle manufacturer for more information.
INSTALLATION / SAFETY INSTRUCTIONS
Step 1
Locate the vehicle battery on the driver’s side under the hood and disconnect
the negative battery terminal.
Step 2
Locate the vehicle connector behind the rear bumper in the center of the
vehicle. The connector will be similar to that on the CURT wiring connector
(A).
Step 3
Separate the vehicle connectors from the weather seal connectors. Take care
not to damage the locking tabs.
Step 4
Insert the CURT wiring connector end into the vehicle connector. Make sure the
connectors are fully inserted with locking tabs in place.
Step 5
When in use, route the 4-flat to the center of the vehicle. When not in use,
roll up and store in a convenient, out-of-the-way location. Secure any loose
wires with the provided cable ties.
Step 6
Reinstall all items removed during installation and reconnect the negative
battery terminal. Install the provided 4-flat dust cover to help prevent
corrosion.
CURTMFG.COM • NEED ASSISTANCE? • 1.877.287.863
4 • 56325-INS-RA • PAGE 2
http://qr.curtmfg.com/video/56325
Scan for helpful installation tips
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>