Home Store More 070987 Buddha With Light Water Fountain Instruction Manual
- October 30, 2023
- home store more
Table of Contents
070987 BUDDHA WITH LIGHT WATER FOUNTAIN|
PLU: 070987 BUDDHA WITH LIGHT WATER FOUNTAIN
Thank you for purchasing this fine decorative fountain.This product combines
our lastest design
with a creative theme,and is carefully packaged, inspected, and tested to
ensure safe
operation. The following instructions and safety guidelines will enable you to
use the product for
trouble-free operation. Please read the insturctions and safety guidelines
entirely before using
the product.
The product consists: (1) Fountain Top (2) Reservoir (3) Pump
Instructions for use:
1. Remove plastic bag from packaging. Read this instruction sheet before
proceeding.
2. Place base on a flat surface, and insert reservoir onto base.
3. Read pump user manual. Insert the water pump into water tube.
4. Insert fountain top on reservoir and put pump into water. Water should be
higher than the
pump.
5. Make sure the water tube is properly connected with the pump, and is not
crimpled.
6. The concave edge of the fountain top should adhere to the convex part of
the reservoir. Be
sure that the electric wire is passed through the wire opening.
7. Connect the power cable to outlet. If installed properly, water flow in
the fountain will begin
shortly.
8. Please do not use the electrical plug in wet weather conditions.
9. Please do not use in adverse weather conditions.
Please note: On first use, there may be air in the pump. It may take several
minutes until all the
air escapes.
Safety Guidelines:
1. Read all instructions and safety guidelines thoroughly. Failure to follow
guideline and
instructions could result in serious injury and/or property damage.
2. Do not pump flammable liquids such as gasoline or fuel oil with the
fountain pump.
3. Make sure the water tube is properly connected with the pump and the upper
layer, and the
tube is not crimpled.This could cause a blockage, and water will not come out.
4. During operation, the area around the pump will be covered with water.
Take care when
handling the pump; do not pull it out of the water (when running) by the power
cord, and do not
move the product while in operation.
5. Unplug the pump from electric power before servicing, cleaning, or moving.
Cleaning and Maintenance:
1. If, after time, the pump starts to lose power or stops working, you should
check for the buildup of sediment or scale at the bottom of the pump housing,
or in the reservoir.
2. Remove the blockage or any dirt and scale which may have built up and
close the case back
up.
3. Periodically change water and keep water clean. We recommend distilled
water to prevent
mineral build-up. This will improve the waterfall effect.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>