ELECTRALITE BeBa_25914 Chrome Fixed IP20 Fire Rated Downlight User Manual
- October 30, 2023
- ELECTRALITE
Table of Contents
FIXED FIRE RATED
DOWNLIGHT
V3 – 02/12/20
Before You Begin ……
- Unpack all components onto a flat surface that will not damage them or allow them to become dirty
- Check that all components are correct and present
- Familia rise yourself with the product, its component parts and how it is assembled.
- Keep all packaging until after a successful installation and retain the instructions for future reference
WARNING: Not suitable for mounting on normally flammable surfaces (e.g.
polystyrene tiles and wood based materials)
WARNING: Before proceeding, make sure the ceiling light is switched OFF
and the electricity is switched OFF at the mains supply board
Suggested tools required for installation process as follows:
- Screwdriver – with insulated handle.
- Pliers – for twisting wire and cutting cable
- Drill – choose appropriate drill bits for your chosen location and mounting surface
SPECIFICATION:
- Suitable for 30 & 60 minutes fire resistant standard ceiling constructions
- Protection against electric shock: Class I (Earthed)
- Material: Die Cast Steel
- PTFE Cable
- Lamp Type: GU10 220-240V ~ 50Hz 35W MAX
- Dimensions: Overall: 116mm, Diameter: 112mm Cut Out 72mm
- Minimum Distance from illuminated object: 0.5m
- Complies with BS EN60598, BS5250, BS476 Parts 20, 21 & 23.
INSTALLATION INSTRUCTIONS:
- Ensure mains supply is switched off; choose a location for your new fitting. Ensure a minimum of 105mm is available, and ensure there at least 100mm of free space around and 50mm above the luminaire, do not cover the luminaire with thermal insulation.
- Make a 72mm round fixing hole. Ensure that the hole is cut correctly, we recommend using a circular hole cutter. Take great care not to damage the decorative finish.
- Make the electrical connections to the terminal block.
- Remove the bulb retaining clip built into the cover this will allow access to the lamp holder, fit the bulb and replace the bulb retaining clip/cover.
- Lift both spring clips upwards and insert into the 72mm ceiling hole, allow the long ends of the spring clips to pass through the hole and the short ends of the spring clips to engage with the ceiling.
- Press the fitting firmly into place until it is retained by the spring clips
- Restore the power supply and switch on.
IF IN DOUBT ABOUT FITTING THIS PRODUCT, PLEASE CONSULT A QUALIFIED ELECTRICIAN
HELPLINE
If you receive this item with parts broken or missing, please telephone: 0333
0050077
Please have ready your name, address, tel. no., product reference, where
purchased and parts required.
An answering service is in operation outside office hours and during busy
periods.
We regret that we are unable to give advice on internal house wiring.
Cascade Holdings Ltd, Gorse Mill, Gorse Street, Chatterton, Oldham. OL9 9RJ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>