KRIP K69 4G Smartphone User Guide
- October 30, 2023
- KRIP
Table of Contents
KRIP K69 4G Smartphone
HOW TO USE
-
Remove SIM tray with ejector tool
-
Insert memory card
-
Insert SIM card(s)
-
Replace SIM tray
-
Insert USB cable and charge for 8 hours
-
Power on and run initial setup
FCC Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
Specific Absorption Rate (SAR) information
This product meets the government’s requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies.
The standards include a substantial safety margin designed to assure the
safety of all persons regardless of age or health. FCC RF Exposure Information
and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of
tissue. Device types: this product has also been tested against this SAR
limit. This product was tested for typical body-worn operations with the back
of the phone kept 10mm from the body. To maintain compliance with FCC RF
exposure requirements, use accessories that maintain an 10mm separation
distance between the user’s body and the back of the product. The use of belt
clips, holsters and similar accessories should not contain metallic components
in its assembly. The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and should be avoided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>