TRX 433MHZ PIR Wireless Pet Friendly Passive Infrared Motion Sensor Instructions

TRX PIR
Wireless Pet-Friendly Passive Infrared Motion Sensor
Instructions

Detection Area

Specifications:

Hardware & Mounting

detection area
|
Do not install outdoors| Do not mount in unstable local ones where shock or vibrations may affect the detector
|
Do not obstruct the detector’s field of view, even partially|

Pairing and Jumper Options

Movement Indicator LED:
Jumper ON = LED ON
Jumper OFF = LED OFF
Walk Test Mode (For testing purposes only, Install in Normal position)
Walk Test = Sends alarm triggers with every motion detection
Normal = Sends alarm trigger & will not generate another for 2mins
Pulse Count
2 = Normal conditions
4 = Hash conditions (makes detector less responsive)

Programming

1. Insert Battery into TRX PIR

2. Connect the TRX Transceiver to the Alarm panel

3. Press the Red Pairing Button on the TRX PIR until the Red Pairing LED starts flashing

4. Now press the Pairing button on the TRX Transceiver until the blue LED starts flashing

5. The Red Pairing LED should stop flashing to indicate the dice are paired successfully

6. Enter programming mode on the Alarm panel (P 000000 E default installer code)

7. Press PROG 122 ENTER then the input number you wish to make wireless, followed by entering,
   Next, make sure options 1 & 5 are ON and ENTER, this makes the input active and wireless

8. Press PROG 164 ENTER then the input number you wish to enroll the device into and ENTER

9. Press ENTER again to start learning, the keypad will start beeping to indicate it’s searching

10. Activate the TRX PIR Tamper switch, the beeping should stop, indicating the device is learned

Testing

1. Once programming is complete, Fit the TRX PIR in place on the wall

2. Enter programming mode on the Alarm panel (P 000000 E default installer code)

3. Press PROG 200 Enter, 6 ENTER, ENTER (keypad will beep & WALK will come up on the display)

4. Leave the room with the detector in it undisturbed for at least 2 minutes.

5. After 2 minutes walk into the room and into the detection zone.

6. The keypad display will then indicate all the inputs that have been triggered.
   These triggers will remain on the display until you exit the Walk test mode.

7. Exit programming mode.

ARROWHEAD ALARM PRODUCTS Ltd.
344b Rosedale Rd,
Albany,
Auckland.
Ph. 09 414 0085
Fax. 09 414 0088
www.aap.co.nz
v2.0

References

• Intruder Alarm Systems, Security Products | Arrowhead Alarm Products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>