Bonzai NR4-141601 Radio Set Instruction Manual
- June 6, 2024
- Bonzai
Table of Contents
Bonzai NR4-141601 Radio Set
The statements should be displayed in the user manual: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Item NO: NR4-141601
Product Name: FUNTEK 2,4G Radio set
TURN ON THE RC SYSTEM
CAUTION: Always turn the transmitters ■witch ON button Please change
batteries when LED status flashes on the transmitter!
HOW TO BIND
- Please tum on the car power.
- Please press BIND and hold ii, and tum on Iha POWER. Let go of the BIND bottom, so ii will enter to Binding process.
- Once the lights go to Stable Green lights. then the Binding process has been done.
HOW TO CONTROL YOUR MODEL
- Raise the tyres off the ground
- Turn the steering wheel to the right and left as far as it will go. The wheels are to follow the steering direction.
- If the wheels operate in the opposite direction, operate the servo Reverse switch (ST in position REV).
- To regulate the driving speed, actuate the throttle/brake
- backward (forward driving, accelerating) or
- forwards (braking, reversing)
