Taizhou 4050-QD2 Heat Transfer Machine Instructions
- October 30, 2023
- Taizhou
Table of Contents
Taizhou 4050-QD2 Heat Transfer Machine
Overview
TRANSFER PARAMETERS
NOTICE
- Use the heat transfer press only as intended
- Please keep children away from the machine
- Make sure correct outlet is before using the device
- Burns can occur from contact with a hot surface
- Please choose an at least 9.25gal ( 35L ) air compressor
- Turn off the device when not in use and remove the power plug
Troubleshooting
Q: When pressed onto the garments, the color of the design is faded, or
transfers are not fully stacked onto the garments.
A: The reason comes from three points, the pressure is not enough, the
temperature is not hot enough or the design has not been pressed for enough
time. You may need to try more to get the right temp, time, and pressure.
Q: The transfers are stacked on the heating platen.
A: Transfers like dark ink-jet transfer paper could be stacked on a heating
platen, you should use a Teflon
to cover the transfer paper. If this happens, please turn off and cool the
machine completely before you try to peel the stacked paper, do not use sharp
items like knives to scrape the heating plate as Teflon maybe scratched.
Q: Hard to peel off the transfer paper or vinyl.
A: Please make sure transfers are warm peel or cold peel, so as to peel off
accordingly.
Q: How to get reasonable pressure?
A: Adjust the pressure now and try to lock down the handle, feel there is a
certain large resist force.
Q: Turn on the power, but the heat press does not work.
A: Pis check the power plug connected well to the socket, you may turn to the
support team if the problem is still remaining.
How To use
You could adjust the air pressure by air regulator, simply pull up the black cap on its top, clockwise to increase, recommended pressure read-out 0.4-0.7Mpa.
Set recommended TEMP, TIME, COUNT
Wait for the heat press heats up to the set temperature, the fire icon shows
heating now.
Let down the heating platen and start the heat pressing.
Place the T-shirt with a Teflon sheet and go for another 8 sec. heat pressing, then finishes the transfer!
Position the substrate and preheat to remove the wrinkles or moisture, continue to place the graphics design on paper or vinyl on the substrate, and cover it with a Teflon sheet.
Take off the T-shirt and peel off the vinyl or paper depending on the cold peel or hot peel.
After ten thousand of swing-away and press, maybe you need to adjust the positioning screw on the back column to make sure the upper heating platen and lower platen are always paralleled. (For Air Pro One and X).
It’s ordinary if you feel some drag force when you slide out or slide back the lower platen, as Magnetic Tech is applied, which makes sure the lower platen won’t slide back when you are threading a T-shirt, also makes sure upper & lower platens are in the correct location after you slide the drawer back.
MNPT fittings link between
Air hose and air compressor, the air hose is inserted into the air regulator’s
tube connector. (Tube connector for the dual station air machine locates on
the machine’s right side which is over the red power witch). Air hose and MNPT
fittings do not involved in the heat press orders, please order them with an
air compressor, the chosen air compressor should be at least 9.25 gal ( 35L ).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>