milwaukee M18 SAL2 Battery Lamp Instruction Manual
- October 30, 2023
- Milwaukee
Table of Contents
M18 SAL2 Battery Lamp
Product Information: M18 SAL2 Battery-Lamp
The M18 SAL2 Battery-Lamp is a portable area light that can be used as lighting independently of a mains power supply. It operates on an 18 V battery and weighs between 7.52 to 8.57 kg depending on the battery size used (2.0 Ah to 12 Ah). The product has a protection class of IP 54, which means it is dust and water-resistant.
Technical Data
-
Battery voltage: 18 V
-
Weight according EPTA-Procedure 01/2014 (2.0 Ah…12 Ah):
7.52…8.57 kg -
Protection class: IP 54
Safety Instructions
It is important to read all safety warnings and instructions before using the
M18 SAL2 Battery-Lamp. Failure to follow the warnings and instructions may
result in electric shock, fire, or serious injury.
Specified Conditions of Use
The area light should only be used as stated for normal use. Do not use the
product in any other way.
Batteries
Lithium-ion batteries used in the M18 SAL2 Battery-Lamp are subject to
Dangerous Goods Legislation requirements. Transportation of these batteries
must be done in accordance with local, national, and international provisions
and regulations.
Product Usage Instructions
- Ensure that the battery is fully charged before use.
- Press the ON/OFF switch to turn on the area light.
- Click the switch once to activate the high mode (78-100% brightness), twice for medium mode (55-77% brightness), three times for low mode (33-54% brightness), four times for strobe mode (10-32% brightness), and five times for SOS mode (<10% brightness).
- To turn off the area light, press the ON/OFF switch again.
- Adjust the height of the area light by pulling the telescoping pole up or down. The minimum height is 1100 mm, and the maximum height is 2200 mm.
Note: For safety, it is recommended to use the M18 SAL2 Battery-Lamp in accordance with the specified conditions of use and follow all safety instructions.
Operating description
Functional description
TECHNICAL DATA BATTERY-LAMP
M18 SAL2
- Lightning time with one fully charged battery (5.0 Ah)
- High Level …………………………………………………………………………………………………………………… ……………… 4,5 h
- Med Level …………………………………………………………………………………………………………………………………… 8,5 h
- Low Level ………………………………………………………………………………………………………………………………….. 13,5 h
- Luminous fl ux (5.0 Ah)
- Mode High………………………………………………………………………………………………………………………………… 2800 lm
- Mode Medium …………………………………………………………………………………………………………………………… 1300 lm
- Mode Low ………………………………………………………………………………………………………………………………….. 860 lm
- Battery voltage………………………………………………………………………………………………………………………………….. 18 V
- Weight according EPTA-Procedure 01/2014 (2.0 Ah…12 Ah) ………………………………………………………. 7,52…8,57 kg
- Protection class
- Dust and water resistance ………………………………………………………………………………………………………………..IP 54
WARNING! Read all safety warnings and all instructions. Failure to follow
the warnings and instructions may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
-
Remove the battery pack before starting any work on the appliance.
-
Do not dispose of used battery packs in the household refuse or by burning them. Milwaukee Distributors off er to retrieve old batteries to protect our environment.
-
Do not store the battery pack together with metal objects (short circuit risk).
-
Use only compatible Milwaukee chargers from the same battery platform for charging battery packs. Do not use battery packs from other systems.
-
Battery acid may leak from damaged batteries under extreme load or extreme temperatures. In case of contact with battery acid wash it off immediately with soap and water. In case of eye contact rinse thoroughly for at least 10 minutes and immediately seek medical attention.
-
Warning: Do not direct the light beam at persons or animals and do not stare into the light beam yourself (not even from a distance). Staring into the light beam may result in serious injury or vision loss.
Don‘t use this tool in wet areas . -
Warning! To reduce the risk of fi re, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack or charger in fl uid or allow a fl uid to fl ow inside them.
-
Corrosive or conductive fl uids, such as seawater, certain industrial chemicals, and bleach or bleach containing products, etc., can cause a short circuit.
SPECIFIED CONDITIONS OF USE
The area light can be used as lighting independently of a mains power supply.
Do not use this product in any other way as stated for normal use.
BATTERIES
- Battery packs which have not been used for some time should be recharged before use.
- Temperatures in excess of 50°C (122°F) reduce the performance of the battery pack. Avoid extended exposure to heat or sunshine (risk of overheating).
- The contacts of chargers and battery packs must be kept clean.
- For an optimum life-time, the battery packs have to be fully charged, after used.
- To obtain the longest possible battery life remove the battery pack from the charger once it is fully charged.
- For battery pack storage longer than 30 days:
- Store the battery pack where the temperature is below 27°C and away from moisture Store the battery packs in a 30% – 50% charged condition
- Every six months of storage, charge the pack as normal.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods Legislation
requirements.
Transportation of those batteries has to be done in accordance with local,
national and international provisions and regulations.
- The user can transport the batteries by road without further requirements.
- Commercial transport of Lithium-Ion batteries by third parties is subject to Dangerous Goods regulations. Transport preparation and transport are exclusively to be carried out by appropriately trained persons and the process has to be accompanied by corresponding experts.
When transporting batteries:
- Ensure that battery contact terminals are protected and insulated to prevent short circuit.
- Ensure that battery pack is secured against movement within packaging.
- Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced.
Use only Milwaukee accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our Milwaukee
service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the
machine type printed as well as the six-digit No. on the label and order the
drawing at your local service agents or directly at: Techtronic Industries
GmbH, Max-Eyth-Straße 10, 71364 Winnenden, Germany.
SYMBOLS
CAUTION! WARNING! DANGER!
CAUTION: Possibly hazardous optical radiation emitted from this product. Do not stare at operating lamp. May be harmful to the eye.
Please read the
instructions carefully before starting the machine.
Safety class III
This tool is only suitable for indoor use. Never expose tool to rain..
IP54 Protection class
Always extend
legs before raising the poles.
Keep hands clear
of housing when collapsig the extension poles.
Do not dispose of waste batteries, waste electrical and electronic equipment
as unsorted municipal waste. Waste batteries and waste electrical and
electronic equipment must be collected separately.
Waste batteries, waste accumulators and light sources have to be removed from
equipment. Check with your local authority or retailer for recycling advice
and collection point. According to local regulations retailers may have an
obligation to take back waste batteries and Waste electrical and electronic
equipment free of charge. Your contribution to re-use and recycling of waste
batteries and waste electrical and electronic equipment helps to reduce the
demand of raw materials. Waste batteries, in particular containing lithium and
waste Electrical and electronic equipment contain valuable, recyclable
materials, which can adversely impact the environment and the human health, if
not disposed of in an environmentally compatible manner. Delete personal data
from waste equipment, if any.
CE: European Conformity Mark
UK
CA
British Conformity Mark
Ukraine Conformity Mark
EAC: EurAsian Conformity Mark
Copyright 2022
Techtronic Industries GmbH Max-Eyth-Str. 10
71364 Winnenden Germany
TEL: +49 (0) 7195-12-0
WEBSITE: www.milwaukeetool.eu
Techtronic Industries (UK) Ltd Parkway
Marlow, SL7 1YL
UK
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>