MONDOLUX MS41 Hartley HE Spotlight Instruction Manual
- June 10, 2024
- MONDOLUX
Table of Contents
Hartley HE
SPOTLIGHT
Product code
MS41
mondolux.com.au Installation Manual
Warnings
-
The safety and compliance of this fitting are not assured unless the following instructions are adhered to. Please retain these instructions for future reference.
-
Always turn the mains OFF prior to installation. See Picture below.
-
The system is IEC 60570:2003+AMD1:2017 certified and Installation must be carried out by a licensed electrician
-
Risk of Electric Shock: Prior to installation or maintenance, disconnect the fitting from power supply and other control wiring. Faulty cables and wiring need to be replaced by manufacturer only.
-
Risk of Burns: When in use, the fitting’s surface may reach high temperatures and can cause skin burns. It is recommended to install the fitting out of reach to avoid any physical contact.
-
It is recommended to always wear safety glasses and gloves during installation.
-
For safety reasons please keep children away from installation site.
-
Please follow below instructions for disposal in accordance with EU Directive WEEE (Waste Electrical and Electronic Equipment):
• Fittings cannot be disposed alongside other household waste.
• Remove the lamp/ battery for decommissioning (if applicable)
• Send them to nearest WEEE collection center. -
For further inquiries, please contact Mondolux at https://www.mondolux.com.au/
Notes
- This fitting requires 220-240V AC/50HZ power input to the driver.
- Do not interchange any parts of this fitting.
- A minimum distance of 75mm is required around the fitting to allow for air ventilation.
- Allow a minimum distance between fitting and illuminated subject of 800mm.
- Do not touch fitting when in use.
- Do not cover with any form of heat proof material.
- If you have any questions about the installation of this product, please contact Mondolux.
Installation Steps
- Ensure the mains power is turned off before installing the fittings.
- Set the adapter switch to “OFF or 0”.
- Check for correct orientation of the adapter.
- Press the adapter into track and turn locking lever to lock the adapter into track.
- Rotate adapter switch to ● select circuit 1 or 3 or 2.
- Ensure that the adapter switch is always set to “OFF or 0” before removing it.
References
- Mondolux | Innovative Commercial Lighting Supplier Australia
- Mondolux | Innovative Commercial Lighting Supplier Australia
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>