MONDOLUX MB01 Sirius Fluorescent Lighting User Manual
- June 10, 2024
- MONDOLUX
Table of Contents
MONDOLUX MB01 Sirius Fluorescent Lighting
Product Information
The Sirius BATTEN Product Code MB01 is a lighting fixture manufactured and imported by Mondolux. The product comes with an Opal Diffuser Screw, End Cap Ceiling, Mounting clip, Screw, LED Strip, Body, and Connector Body. The installation of the product must be carried out by a licensed electrician to ensure safety and compliance. The system is IEC 60570:2003+AMD1:2017 certified. It is recommended to wear safety glasses and gloves during installation and keep children away from the installation site for safety reasons. The fitting’s surface may reach high temperatures when in use, which can cause skin burns. Hence, it is recommended to install the fitting out of reach to avoid any physical contact.
Product Usage Instructions
- Always turn off the main’s power before installation.
- Connect the main supply wires to WAGO connectors, ensuring all connections are tight.
- Insert 3 PCs WAGO connectors into the holes.
- Fix the fixture with a mounting clip onto the ceiling.
- Reconnect power.
- The installation is complete.
Warnings Instruction
- The safety and compliance of this fitting are not assured unless the following instructions are adhered to. Please retain these instructions for future reference.
- Always turn the mains OFF prior to installation. See the Picture below.
- The system is IEC 60570:2003+AMD1:2017 certified and Installation must be carried out by a licensed electrician
- Risk of Electric Shock: Prior to installation or maintenance, disconnect the fitting from the power supply and other control wiring. Faulty cables and wiring need to be replaced by the manufacturer only.
- Risk of Burns: When in use, the fitting’s surface may reach high temperatures and can cause skin burns. It is recommended to install the fitting out of reach to avoid any physical contact.
- It is recommended to always wear safety glasses and gloves during installation.
- For safety reasons please keep children away from the installation site.
- Please follow the below instructions for disposal in accordance with EU Directive WEEE (Waste Electrical and Electronic Equipment):
- Fittings cannot be disposed of alongside other household waste.
- Remove the lamp/ battery for decommissioning (if applicable)
- Send them to the nearest WEEE collection center.
- For further inquiries, please contact Mondolux at https://www.mondolux.com.au/.
Notes
- This fitting requires 220-240V AC/50HZ power input to the driver.
- Do not interchange any parts of this fitting.
- Do not touch fitting when in use.
- Do not cover with any form of heat-proof material.
- If you have any questions about the installation of this product, please contact Mondolux.
Installation Steps
- Ensure the mains power is turned off.
- Connect main supply wires to WAGO connectors, making sure all connections are tight.
- Put 3 PCs WAGO connectors into the holes.
- Fix the fixture with a mounting clip onto the ceiling.
- Reconnect power.
- Installation is complete.
Installation Diagram
Manufacturer and Importer Details
Manufacturer: Mondolux
Address: 10 Plane Tree Ave, Dingley Village VIC, 3172, Australia.
Phone: +61 9551 3748
Web: www.mondolux.com.au.
Importer: Lovisa Germany GMBH
Address: RichmondStrasse 6, Neumarkt-Galeri 50667 Cologne, Germany.
TIN: DE340001753
EORI: DE895514661097043
References
- Mondolux | Innovative Commercial Lighting Supplier Australia
- Mondolux | Innovative Commercial Lighting Supplier Australia
- Mondolux | Innovative Commercial Lighting Supplier Australia
- Mondolux | Innovative Commercial Lighting Supplier Australia
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>