Atlanta ATH-2533 Electric Kettle Instruction Manual

ATH-2533 Electric Kettle

Instruction Manual

ATH-2533 Electric Kettle

DEAR CUSTOMER!
CONGRATULATIONS ON YOUR GOOD CHOICE! NOW YOU ARE THE OWNER OFTM PRODUCT NOTABLE FOR ITS PROGRESSIVE DESIGN AND  GOOD QUALITY PERFORMANCE. WE HOPE OUR PRODUCTS WILL STAY WITH YOU FOR YEARS ON END.

BEFORE OPERATING

Please read these operating instructions before kettle operating. Before the first use or in case of long time interruption in operation it is recommended to pour water to the  maximum level mark and bring it to the boiling. Pour off the boiled water, repeat the procedure twice.
Do not pour cold water only, which will complete boiling, and still very hot kettle. A large temperature difference can bad affect the materials used in the kettle. Please wait until the kettle has cooled down a bit.

SAFETY MEASURES

• The kettle operates from power supply; power supply technical characteristics are specified on the factory marking of device.

• As surface temperature of the kettle can be over 60 °С, do not touch it except for a handle and buttons.

• Distance between the kettle and other appliances above it must be over 50 cm in order not to be damaged by steam. Avoid close position to other appliances that are  easily distorted due to high temperature.

• The device is not intended for use by persons (including children) with reduced physical, sensory or mental ability or if they have no experience or knowledge, if they are  not under control or not instructed on the use of the instrument the person responsible for their safety.

• Do not leave the appliance unattended when the kettle is plugged in or when children are around. A power supply cord must not be hung down as children can pull it,  throw the kettle and get burnt.

• To avoid the danger, if the power cord has been damaged, it should be replaced by the manufacturer, its agent or similar qualified person.

• The kettle must be used only upright. Never use it on uneven and non-heatresistant surface.

• Use a separate socket for the kettle.

• In case of connecting the device never use the electrical extension cord.

• In order to avoid a fire or electric shock:
  – do not scrape the body of the kettle;
  – do not expose the electric part of the kettle to rain or water exposure;
  – do not submerge the kettle into water or other liquid;
  – KEEP THE APPLIANCE PLUGGED OUT IF IT IS NOT USED, THE DEVICE IS DANGEROUS EVEN IF IT IS UNPLUGGED;
  – do not cover the kettle;
  – do not use the kettle in wet places;
  – do not plug in the kettle if there is water on its base’s surface;
  – do not plug in and plug out by wet hands;
  – do not allow overheating of a plug; it must be fully and tightly put into a socket;
  – do not the kettle if a power supply cord is damaged or soaked;
  – plug out the kettle before cleaning and wait until it has cooled down completely after use;
  – never pull a power supply cord to switch off the appliance, just pull carefully a plug from an outlet;
  – keep the appliance in a dry and cool place.

• The device is designed for indoor use, exclusively for domestic use. Do not use the appliance for professional purposes.

• In case of any work failure, please, apply to the nearest maintenance center with a warrantee certificate. Never fix problems by yourself.

• Don’t arrange kettle near sources, such as: heating radiators, gas stoves, or at places exposed to direct sun rays, excessive dust, mechanical vibration or impact loads.

• In case of transportation under the reduced temperature conditions do not plug in the kettle less than two hours of its storage in warm place. Don’t use any reactive liquids (gasoline, kerosene, alcohol, different solvents) for appliance cleaning.

• Any errors in storage, transportation and use of the device are not covered by the warranty.

KETTLE BASIC ELEMENTS

A – lid of kettle
B – LED display
C – button for switching on and selecting the temperature
D – operating mode indicator
E – handle
F – base unit
G – kettle housing
H – filter (inside the beak)
I – water level
J – power supply cord

PERFORMANCE SPECIFICATIONS

With delicate handling service life can significantly exceed the period set by the manufacturer.
Date of production is represented on the label of the product in the format MM.YYYY

OPERATION

1. Arrange kettle with the base unit at flat dry heat-resistant surface as close to the socket as possible.
2. Insert the kettle plug into the socket, making sure that the kettle is turned off.
3. Fill the kettle with water through the top open. Water volume shall be not less than 0.5 l , but not more than the volume marked at the scale as «MAX».
4. Tightly close the top of the kettle otherwise the kettle won’t switch off when boiling.
5. Place the kettle on a stand that is connected to the mains. The current water temperature will be displayed on the display, and the operation indicator will light up in  green. The design of the kettle allows you to install it on a stand on either side.
6. Briefly press the power button (C) to simply boil the water, a single beep will sound, and the operation indicator will turn red.
7. Wait until the water boils. The kettle will turn off automatically, two beeps will sound, and the operation indicator will turn green. The operation indicator will turn off after 5 minutes, after the water boils. To re-boil, you need to wait until the kettle cools down a little and the temperature sensor comes to its original position.
8. If you need to heat the water to a temperature of less than 100 °C (40/50/60/70/80/90), turn the temperature selection button to the desired value, and briefly press the power button. The display will display the desired temperature with a triple flash, one beep will sound, the operation indicator will light up red, the kettle will start working. The display shows the current water temperature. The kettle will turn off automatically when the temperature reaches the set value. Two beeps will sound, and the operation indicator will turn green.
9. This model can also operate in the mode of maintaining the set temperature. To do this, you need to turn the temperature selection button to the desired value, press the power button and hold it for 2 seconds. The power button will turn red and flicker. The symbol will light up on the display . The display will display the desired temperature with a triple flash, one beep will sound, the operation indicator will light up red, the kettle will start working. The display shows the current water temperature. The kettle will turn off automatically when the temperature reaches the set value. For 2 hours, the kettle will automatically maintain the set temperature, including heating, to the set temperature, if it falls by more than 10% of the set value. If you remove the kettle from the stand, the set values are reset to zero. To continue working in the specified mode, you must set the required values.
10. Don’t open the top in the process of boiling and immediately after in order to avoid thermal injury.

NOTES

1. Never fill the kettle with any liquid except water.
2. Be money-saving: don’t boil more water than you need. This will reduce power consumption and increase the operating life of the kettle.
3. Condensate may appear in the kettle in the course of operation.
4. Never heat the kettle on gas or electric stove.
5. The kettle shall be used only with the base completed with the supply.
6. The manufacturer reserves the right to make additional change in the kettle.

CLEANING AND CARE

• The kettle must be cleaned regularly in order to remove calciferous sediments. A bulk of sediments on a heating element can cause a breakage of the kettle.

• Plug out the kettle and let it cool down, then clean it with a wet cloth using soda.
  Do not use reactive and abrasive detergents as they can damage a surface of the kettle.

• Do not use tools when cleaning the kettle.

• To prevent calciferous sediments getting to your cup the kettle is equipped with a filter that must be regularly washed with water. The sediment appeared due to lime water boiling inside of the kettle is not harmful.

• The kettle must be thoroughly washed after cleaning.

• Never put the device into water or another liquid.

ENVIRONMENTAL PROTECTION

**** The old devices are the package of the technical materials; therefore they can not be recovered with the domestic waste! On that reason, please, support us in the resources  saving and environmental protection and return the unit to the recycling center (if applicable).

www.atlantastore.ru

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>