Stelrad Radiator Thermostat RAS-D2 Combi Pack, Radiator Pack Instructions
- June 10, 2024
- Stelrad
Table of Contents
Radiator Thermostat RAS-D²
Combi Pack / Radiator Pack
BI-DIRECTIONAL ANGLED VALVE WITH FLOW-SELECTABLE FEATURE
Installation of valve
The valve is a bi-directional valve * and can be installed horizontally or
vertically in either the flow or return pipe.
A built in flow direction selection feature can be used to eliminate the risk
of water hammer. We recommend using a flat faced adjustable spanner and a soft
cloth to protect the chrome surfaces when tightening up the connections.
Troubleshooting
In the unlikely event of water hammer being encountered turn the setting ring
(see diagram 4) to the other setting.
Alternatively if commissioning the whole system, establish the flow direction
through each valve using the diagrams below.
If the flow direction needs to be changed there is no need to remove the
valve, simply turn the setting ring.
Fitting the Sensor
-
Remove cap from valve and turn sensor to
-
Press the sensor firmly onto the valve. Sensor horizontal: ensuring that the scale pointer is at top.
Sensor vertical: ensuring that the scale pointer is at the front. -
Whilst holding the sensor firmly on the valve secure connection by tightening the Allen screw using the enclosed key.
-
Set desired room temperature.
Setting the desired room temperatures
The desired room temperature is set by turning the head.
The temperatures obtained are approximately:
Do not cover the thermostat
The thermostat opens and closes as determined by the temperature around it.
Therefore the sensor must never be hidden behind thick curtains, furniture,
etc. Alternatively a thermostat with remote sensor should be used.
Positive SHUT-OFF feature:
The head can be turned past the setting (a slight resistance will be felt) to
setting “0” at which point the water flow is shut off completely. After also
shutting the lockshield valve the radiator may be drained and removed for
maintenance and decoration purposes.
Lockshield valve RLV-D is included
Removing the Sensor
Loosen the Allen screw (3).
The sensor can now be separated from the valve.
What is a thermostatic radiator valve (TRV)?
… an explanation for householders.
TRVs sense the air temperature around them and regulate the flow of water
through the radiator which they are fitted to. They do not control the boiler.
They should be set at a level that gives you the room temperature you want.
These settings may have to be different in each room, and you should set the
TRVs to suit each room and then leave them to do their job.
Turning a TRV to a higher setting will not make the room heat up any faster.
How quickly the room heats up depends on the boiler size and setting, and the
radiator size. Turning a TRV to a lower setting will result in the room being
controlled at a lower temperature, and saves energy.
TRVs need a free flow of air to sense the temperature, so they must not be
covered by curtains or blocked by furniture.
TRVs cannot turn off the boiler when the whole house is warm. To do that, you
will need a room thermostat as well.
The radiator in the room with the room thermostat should not normally have a
TRV, but, if it does, keep the TRV on the maximum setting and adjust the room
thermostat as explained with the instructions.