Amico Powered Cart with Standard Interface User Guide
- June 10, 2024
- Amico
Table of Contents
Amico Powered Cart with Standard Interface
Product Information
The Powered Cart with Standard Interface is a mobile computer workstation designed for medical facilities. It comes with both automatic and manual height adjustment features for user convenience. The cart has an AC power indicator and a recovery battery level indicator to keep the user informed about the power status. The product is manufactured by Amico Accessories Inc., a company based in Richmond Hill, Canada.
Product Usage Instructions
- Inspect the cart integrity prior to beginning setup.
- Refer to the full manual for complete installation instructions.
- For automatic height adjustment, follow the quick setup instructions provided in the full manual.
- For manual height adjustment, refer to the quick setup instructions provided in the manual.
- Use the AC power indicator to ensure the cart is connected to a power source.
- Use the recovery battery level indicator to monitor the battery level and recharge as needed.
- As a medical facility, it is your responsibility to ensure proper use and maintenance of the product.
Note: This Quick Guide is not a replacement for the full manual. It is the responsibility of the end user to ensure all aspects of the installation are covered by following the full manual.
Automatic Height Adjustment
Medical Facility Responsibility
WARNING: This Quick Guide is not a replacement for the full manual. It is
the responsibility of the end user to ensure all aspects of the installation
are covered by following the full manual.
NOTE: Inspect the cart integrity prior to beginning setup.
- First Time Initializing:
- Briefly plug the cart into the power outlet. The AC Power Indicator should illuminate (the may take up to 30 seconds).
- After initializing the cart, the two arrow buttons (Figure 1) will begin to flash, indicating that the user must set the cart’s “Home” (lowest) position.
- Setting Home Position:
- Hold the Down arrow to lower the cart’s worksurface until only the Down arrow is flashing.
- Release the Down arrow and reverse direction to raise worksurface to desired position.
Manual Height Adjustment
Medical Facility Responsibility
WARNING: This Quick Guide is not a replacement for the full manual. It is
the responsibility of the end user to ensure all aspects of the installation
are covered by following the full manual.
NOTE: Inspect cart integrity prior to beginning setup.
- First Time Initializing:
- Briefly plug the cart into the power outlet. The AC Power Indicator should illuminate (this may take up to 30 seconds).
Manual Height Adjustment
Figure 1
Amico Accessories Inc. | 85 Fulton Way, Richmond Hill, ON L4B 2N4, Canada |
www.amico.com
Toll Free Tel: 1.877.264.2697 | Tel: 905.763.7778 | Fax:
905.763.8587 | Email: info@amico-accessories.com
AA-QG-MOBILE-COMPUTER-WORKSTATION-HUMMINGBIRD-STANDARD-INTERFACE 09.11.2020
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>