KAITHIN KRS-001-BLK Replacement Voice Remote with Samsung TVs User Manual
- June 10, 2024
- KAITHIN
Table of Contents
KAITHIN KRS-001-BLK Replacement Voice Remote with Samsung TVs
INTRODUCTION
Use this remote control to replace your lost or broken Samsung remote to work your Samsung TV and sound bar (if applicable). Although the remote is designed to be paired to the TV, it also transmits IR. So, this remote control can also be used as an IR remote control to allow for limited functionality with TVs that have an IR remote control sensor. This remote control can also be used to control functions on a compatible Samsung soundbar if the soundbar is paired with the TV. The remote control will not control the soundbar if it is only connected to the TV with cables.
Note:
You can use the remote control up to 20 feet or more from the TV. The range
may vary depending on the wireless environmental conditions.
INSTALLING THE BATTERIES
INSTALLING THE BATTERIES (Not Included)
Press and slide back cover off. Insert 2 AA batteries into the battery
compartment. Make sure that the positive and negative ends are facing in the
correct direction. Close the rear cover again.
PAIRING YOUR REMOTE WITH YOUR SAMSUNG TV:
Before using your remote control, you need to pair it with your Samsung TV.
After installing batteries, with the TV in standby mode, point the remote at
the remote control sensor of the TV, and then press and hold the buttons
labeled & simultaneously for 3 seconds or more.
BATTERY CAUTIONS
- To prevent battery leakage damage, remove the batteries when drained or if the product will not be used for an extended period.
- When installing batteries, make sure to align the +/- direction correctly.
- Do not mix old and new, or different types, of batteries.
- Dispose of used batteries following your local regulations.
SAFETY AND CARE INSTRUCTIONS
Please read and understand all instructions before using this product. If damage is caused by failure to follow the instructions, this warranty is null and void.
- Keep these instructions.
- Do not drop, puncture, or disassemble this product.
- Do not expose this product to dripping or splashing of drinks or liquids of any kind.
- Avoid long exposure to direct sunlight, which may cause damage.
- Do not expose this product to open flames.
- Do not use the product in a strong magnetic field.
- Use a clean, soft cloth to clean. Do not use any corrosive cleaners/oils to clean.
- Do not attempt to repair the device or open the unit as this will void the warranty.
CONTROLS AT A GLANCE
SUPPORTED MODELS:
Samsung 6 Series, 7 Series, 8 Series, QLED Q60T Q07T Q08T Series Smart TV,
such as RU9000 -TU8000 – TU8300 – Q60T – Q70T – Q80T -Q90T -Q900TS -Q950TS
-LST7 -LS06 -RU8000 – 050 – 060 – 070 -Q80 Q900 -NU-8000 -NU8500 -Q6F -Q7F
-Q7C -Q8F -Q9F Series
Further Details
PRESS WORK: TRIM TO SIZE, SCORE, FOLD & GLUE WHEN SPECIFIED
- SCALE: 100%
ASSEMBLED PACKAGE DIMENSIONS ( in Inches)
- WIDTH: 5″
- HEIGHT: 6″
- DEPTH: N/A
DIELINE OVERALL DIMENSIONS ( in Millimeters)
- WIDTH:
- HEIGHT:
PACKAGING MATERIALS, THICKNESS & SIZE
- SUBSTRATE TYPE: 400 gsm Giftbox
- WINDOW: INNER TRAY
- MAGNET:
- VELCRO:
- SECURITY STICKERS: 020mm
- HANG TAB:
- FOAM:
- CORRUGATED BOARD:
- PLASTIC BAG:
- MANUAL: 128gsm
PACKAGING TYPES
- FOLDING CARTON: Print 4/0
- FOLDING CARTON WITH DOOR PANEL:
- RIGIT GIFT BOX:
- CLAMSHELL:
- SLIDING/SLIPCASE:
- TRAPPED BLISTER CARD
- BLISTER CARD:
- OTHER:
PRESS SPEC COLOR REFERENCES
-
DIELINE
-
GLOSS UV SPOT
-
EMBOSSING (RELIEF)
-
DEBOSSING (SUNKEN)
-
FOLDING LINE
-
PRODUCT PLACEMENT
-
FOILING
-
GLUE FOLD
-
020mm SECURITY STICKERS PLACEMENT
-
BLISTER OR INNER TRAY PLACEMENT
-
CLOTH LIFT TAG
-
CLEAR WINDOW 0.3mm
-
CLEAR WINDOW 0.3mm
Warranty
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
ONE YEAR WARRANTY
Xtreme warrants its products for one year against defects in manufacturing
under regular consumer use with the original receipt of retail purchase. We
believe in our products and want to provide you with a replacement if needed,
but we have to know about the problem while the product is still under
warranty. If you discover a defect covered by this warranty, please contact us
about receiving a replacement. In order to use the product’s warranty the
customer must provide proof of the retailer’s receipt.
Any customers outside of the U.S. will be responsible for shipping and handling charges if a replacement is required that is not due to a manufacturing defect. If there is not manufacturing defect, shipping, and handling will be applied.
Xtreme’s warranty is limited to our products only. Our warranty does not cover the replacement or repair cost of any third-party accessory, electronic device, or personal property. For instructions about how to obtain warranty service for your product, please contact Customer Service: customerservice@xtremecables.com.
FCC STATEMENT
FCC statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures
- Reorient or relocate the receiving antenna.
- • Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected,
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of Ocm between the radiator & your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
SPECIFICATIONS
- Requires 2x AA Batteries (Not Included)
- Dimensions: 1.3″(w) x 6.3″ (H) x 0.9″ (D)
Contact Information
KRS-001-BLK
855.999.8041 WWW.KAITHIN.COM.