PERRY ELECTRIC 1DCAMF05C Energy Efficient Hand Dryer Instruction Manual
- June 10, 2024
- PeRRY ELECTRIC
Table of Contents
PE – DEDCPE001 04/20
EOLO JET
Energy efficient hand dryer
INSTRUCTIONS FOR INSTALLATION AND USE
1DCAMF05C Energy Efficient Hand Dryer
mod. 1DCAMF05
1DCAMF05C
- Drying time
- Energy saving
- Compact dimensions
- Design
- Antivandalism
PRODUCT PRESENTATION
EOLO JET guarantees rapid drying, while promoting a high level energy and
consumption savings.
Despite this, its performance remains excellent.
The hand dryer comes into operation and automatically stops by hands
approaching and moving away from the cone air outlet.
Its design is simple and of the latest generation, available both in the WHITE
ABS and in the CHROME ABS versions.
This appliance has been built with care and precision. Quality tests and
testing during the manufacturing phase, guarantee total and efficient
operation.
SAFETY WARNINGS
ATTENTION: We invite to read carefully and to hold these
instructions.This manual supplies important informations regarding maintenance
and use, installation, emergency. A wrong installation can produce damages to
persons or things, which the constructor cannot be thought responsible about.
Important: the manufacturer reserves the right to introduce any technical
and/or constructive changes deemed necessary, with no prior notice.
Make sure that you have disconnected the 230V~ power supply before proceeding
with installation or maintenance.
****Do not use this product for a different function from that to which it is
intended:
- Do not leave the appliance exposed to atmospheric conditions such as rain, sun,
- Make no changes of any kind to the device
- Do not obstruct the air outlet or mouth
- Do not insert any object into the grid or the outlet air
In case of failure and / or malfunction, remove the mains and consult with
the person technical qualification (qualified electrician).
To maintain the correct functioning of the device, it is advisable to carry
out the necessary maintenance (see page 6).
2.1 – STANDARDS FOR ELECTRIC SAFETY
IMPORTANT: the installation, electrical connection and maintenance of the
appliance must be implemented only by a qualified electrician and in
conformity with current laws and regulations. The manufacturer declines all
liability in connection with the use of products subject to special
environmental and/or installation standards.
THE APPLIANCE MUST BE INSTALLED IN COMPLIANCE WITH STANDARD CEI-64-8 / 7,
REFERRED TO THE PRODUCT CHARACTERISTICS.
2.2 – STANDARDS RAEE
DISPOSAL OF ELECTRICAL & ELECTRONIC EQUIPMENT
This symbol on the product or its packaging to indicates that this product
shall not be treated as household waste. Instead, it shall be handed over to
the applicable collection point for the recycling of electrical and electronic
equipment, such as for example:
sales points, in case you buy a new and similar product;
local collection points (waste collection center, local recycling center,
etc…).
By ensuring this product is disposed of correctly, you will help prevent
potential negative consequence for the environment and human health, which
could otherwise be caused by inappropriate waste handing of this product.
The recycling of materials will help to conserve natural resources. For more
detailed information about recycling of this product, please contact your
local city office, your house hold waste disposal service or the shop where
you purchased the product.
TECHNICAL DATA
Cover materials | ABS |
---|---|
Base materials | ABS fireproof |
Functioning | Automatic |
Supply voltage | 220-240 V~ |
Frequency | 50-60 Hz |
Isulation type | Classe ll |
Protection degree | IP 23 |
Motor type | Brushes |
Brushes | 500 hours |
Motor revolution | 28.000 rpm |
Motor absorption | 400 W |
Resistance absorption | 500 W |
Total absorption | 900 W |
Automatic off | 90 sec. |
Air flow | 110 mc/h |
Air speed | 200 km/h |
Sound level (2mt.) | 75 db |
Sensors sensitivity adjustment | YES |
Drying time | 20 sec. |
Air temperature | 45° |
Antibacterial filter | EPA E11 (accessory) |
Weight | 1,2 kg |
Dimensions (A x L x P) | 238 x 156 x 99,5 mm |
Power plug | Bipolar 10A |
3.1 – DIMENSIONS
INSTRUCTIONS FOR INSTALLERS
This hand dryer has to be fixed at proper distance of at least 80 cm from
bathtub or shower or washbasin.
Please verify that the electrical capacity of the system and the female plugs
of current is adapted to the maximum power of the apparatus.
It is necessary to install a bipolar switch upstream of the appliance with a
contact opening of at least 3 mm.
We recommend fixing the towel at a height of about 120 cm from the floor the
air outlet cone and, in the case of photocell towels, at a distance at least
40 cm. from reflective
surfaces, such as glossy white washbasins, that the photocell could mistakenly
detect.
For installation, use the attached assembly sheet and the plugs and screws
supplied in the package.
This appliance can be used by children from 8 years of age and by people with
reduced physical, sensory or mental abilities, or with lack experience and
knowledge if they are
under adequate surveillance, or if they have been instructed about the use of
the appliance safely and if they realize of related dangers.
Children must not play with the appliance.
Children must not perform cleaning and maintenance procedures unless
supervised.
If the power cord is damaged should be replaced by person technical
qualification (qualified electrician), to prevent any risk.
4.1 – SECURITY SYSTEM
The device has a system that prevents vandalism continuous operation, caused
for example by covering the photocell. If this occurs, the dryer can work
without interruption for about 90 seconds, then automatically stops waiting
for (stand by) It will be simply needed to remove the cover that blocks the
photocells to ensure the dryer to resume its normal function in 3-4 seconds.
4.2 – WALL MOUNTING![PERRY ELECTRIC 1DCAMF05C Energy Efficient Hand Dryer
- fig](https://manuals.plus/wp-content/uploads/2023/05/PERRY-ELECTRIC- 1DCAMF05C-Energy-Efficient-Hand-Dryer-fig.jpg)
OPERATING
The hand dryer comes into operation and automatically stops by hands
approaching and moving away from the cone air outlet.
Warning: In case of an overload of internal temperature, a thermostat
with automatic reset protection suspends the operation of the engine. This
device gives the user major safety.
MAINTENANCE
Make sure that you have disconnected the 230V~ power supply before proceeding
with installation or maintenance.
Clean this hand dryer, by using a soft cloth dampened with water and
detergent.
To ensure the durability and reliability of this product, periodically check
that the grid inlet and outlet of the air cone are not clogged by dust or any
equivalent material.
IMPORTANT: this operation must be carried out by qualified personnel.
It is possible that over time or depending on the surrounding environment
(reflective surfaces or very close to), the activation sensors need
calibration. This operation can be simply carried out thanks to the trimmer on
the electronic board (round element located on the left of the sensors), using
a screwdriver with a small tip. Turning clockwise direction the reading
distance of the sensors will be decreased to zero (it will have to decrease in
the case of false activations due to light reflected by the washbasin or shiny
floors). Anticlockwise, the distance will be gradually increased and the
device will be able to detect the hands up to about 20 cm away it will have to
increase if there is a need to bring your hands too close to the device to
activate it).
BRUSH MOTOR (carbon brushes) – Replacement
The motor brushes cartridge in the drive unit has a life of 500 hours of
effective operation. The duration of thesame varies depending on the
conditions of use and of cleaning the filter and general mantainance of the
appliance.
It is needed to contact the customer service to restore the brushes at the end
of the cycle.
Important: also excluded from the warranty consumable items (cartridges carbon
motor, filter), whose life depends on the terms and conditions of use.
EPA FILTER (optional)
The Epa filter inside the machine, if present, guarantees air to be cleaned
from excessive dust and dirt.
The filter must be periodically cleaned with a jet of compressed air at a
distance of about 20 cm. It must be replaced after a maximum of 1000 hours of
use, in conjunction with the car tridges motor brushes. The quality E11 EPA
filter paper, if maintained in good condition and replaced as required above,
it is able to protect against bacteria and external factors that can go up to
97.66% of airborne particles.
PERRY ELECTRIC Srl
Via Milanese, 11 – 22070 VENIANO (CO) ITALY
–www.perry.it
Tel. +39. 031. 89441 – Fax +39. 031. 8365201
PERRY ELECTRIC Srl
Via Milanese, 11 – 22070 VENIANO (CO) ITALY –
www.perry.it
Documents / Resources
|
PERRY ELECTRIC 1DCAMF05C Energy Efficient Hand
Dryer
[pdf] Instruction Manual
1DCAMF05C Energy Efficient Hand Dryer, 1DCAMF05C, Energy Efficient Hand Dryer,
Efficient Hand Dryer, Hand Dryer, Dryer
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>