Eufy Security S330 eufyCam T8160 User Manual

Eufy Security S330 eufyCam T8160

QUICK START GUIDE

AT A GLANCE

S330 eufyCam

Model: T8160

S380 HomeBase

Model: T8030

EXPANDING STORAGE (OPTIONAL)

S380 HomeBase comes with 16 GB of storage for saving video recordings and allows you to add an additional hard drive to expand the space

Prepare Your Hard Drive

Your hard drive must meet the following requirements

Type| Hard disk drive (HDD) or solid state drive (SSD) that uses the SATA interface
---|---
Size| 2.5 inch
Capacity| Unlimited
Recommended| Western Digital, Seagate, SAMSUNG, Kingston, PNY, Crucial, SanDisk

WARNING : Transfer all the data in your hard drive to a secure location before adding it to S380 HomeBase

Install Your Hard Drive

S380 HomeBase must be powered off when you install or remove a hard drive.

1. Push down the top lid to remove it.

2. Loosen the screw, then pull out the hard drive bracket.

3. Fix your hard drive to the bracket with the provided screws.

4. Insert and screw the bracket back to S380 HomeBase, then put the top lid back into place.

• You can follow the steps above to expand the storage whenever necessary.
• A new hard drive must be initialized through the eufy Security app to work with S380 HomeBase.

SETTING UP

1. Power and connect S380 HomeBase to your router. The LED indicator will turn blue (This may take about 1 min) when S380 HomeBase is ready for setup.

2. Download and install the eufy Security app, then sign up for an account.

3. Follow on-screen instructions to add S380 HomeBase and the cameras to your device list(*).

• One S380 HomeBase can pair up to 16 cameras.

CHARGING THE CAMERA

Fully charge both cameras before first use. This may take about 8 hours for each.

S330 eufyCam includes a solar panel that converts sunlight into electrical energy and keeps the built-in battery charged every day.

The charging efficiency fluctuates according to the intensity of the sunlight.

Don’t worry when the battery level goes down. It happens when there isn’t enough sunlight or the camera is consuming more power than usual.
You don’t need to charge the camera with a cable until a low battery alarm goes off.

**2 HOURS PER DAY***

• Make sure the solar panel can be fully exposed to direct sunlight for at least 2 hours per day.

MOUNTING THE CAMERA

Select a Location

Select a location where you can get the desired view. We recommend hanging the camera 7-10 ft (2-3 m) above the ground.

Best places to install:
– Wall without eaves
– A pole or fence where sunlight is not blocked
– Over eaves, if the eaves are below 3 m high

Places not to install:
– Inside your home or under the porch
– Under or on a tree
– Under slanted eaves

Mount the Camera

1. Turn the knob of the mounting bracket counterclockwise to loosen and disassemble it.

2. Drill holes with a 15/64 inch (6 mm) drill bit, then insert the anchors into the holes; anchors are necessary for walls that are made out of hard materials such as concrete, brick, or stucco.

3. Firmly screw the knob of the mounting bracket into the mounting hole.

4. Hold and screw the camera to the mounting bracket. Rotate the camera to adjust the view and check it using the live stream, which you can access in the eufy Security app.

For troubleshooting, check Help on the eufy Security app. Refer to the app page for LED indicator status.

SAFETY

• Do not use the device in the environment at a too high or too low temperature, never expose the device to strong sunshine or too wet environment.
• The suitable temperature for T8030 and accessories is -10°C to 45°C .
• The suitable temperature for T8160 and accessories is -20°C to 50°C (Charging temperature is 0°C to 45°C) .
• It is recommended to supply the device in an environment with a temperature that ranges from 5°C~25°C.
• When supplying, please place the device in an environment that has a normal room temperature and good ventilation.
• The adapter shall be installed near the equipment and shall be easily accessible.
•  Please ensure to use only the adapter offered by the manufacturer. Using unauthorized adapter may cause danger and violate the authorization of the device and the guarantee article.
• This adapter is for indoor use only. The adapter type (for S380 HomeBase) is KA2401A-1202000DE, rated output voltage/current is 12 Vdc/2A. The plug is considered as disconnect device of adapter.

Warning:

• Replacement of a battery with an incorrect type can defeat a safeguard;
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery can result in an explosion;
• Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas; and
• A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

CAUTION : RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

NOTICE

NOTICE (Europe and United Kingdom)

CE : This product complies with the radio interference requirements of the European Community.

Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the website: https://uk.eufylife.com.

This product complies with the radio interference requirements of the United Kingdom

Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with Radio Equipment Regulations 2017(SI 2017/1206). The full text of the UK declaration of conformity is available at the following internet address: https://uk.eufylife.com.

RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use products that maintain a 20cm distance between the device and human body.
Frequency bands and power as below:

The following importer is the responsible party (contract for EU matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany
The following importer is the responsible party (contract for UK matters):
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

 This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

DOWNLOAD

Eufy Security S330 eufyCam T8160 User Manual – [Download PDF]

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>