CUSCO 1A9-820-SS Side Skirt Set Instruction Manual
- June 10, 2024
- Cusco
Table of Contents
CUSCO 1A9-820-SS Side Skirt Set
Product Information
- Part No.: 1A9-820-SS
- Vehicle : 2019+ Toyota Corolla Hatchback
- Kit Includes : Unpainted Side Skirt Set x1, M6 x 20mm Bolt x 10, M6 Nut x10, M6 Washer x10
Product Usage Instructions
-
Remove the OE Side Steps from the vehicle.
-
Temporarily install the CUSCO Side Skirt on the OE Side Step and align it properly. Then, drill holes on the OE Side Step by using the supplied M6 x 20mm Bolts (x10).
-
Temporarily install the CUSCO Side Skirt by using the supplied hardware to check if all holes are lined up. Drill holes (x5) if necessary.
-
Paint the part.
Note : If you use a high-temp paint baking process, the Wing might be deformed. -
Final installation of the CUSCO Side Skirts should be done using the supplied hardware. Use caulking material (not included in this kit) for competition use if needed.
Installation
-
Remove OE Side Steps out from the vehicle. Temporally Install CUSCO Side Skirt on the OE Side Step and align the position properly. Then drill holes on OE Side Step by (x10)
-
Temporally Install CUSCO Side Skirt by using supplied hardware to check all holes are lined-up.
-
Paint the part
Caution : If used high-temp paint baking process, the Wing might be deformed -
Final Installation Install CUSCO Side Skirts by using supplied hardware. Use Caulking material (not included in this kit) for competiotion use if needed
