Steba IK23oT Induction Hob Instruction Manual

IK23oT Induction Hob
Instruction Manual

IK23oT Induction Hob

www.steba.com

Control panel: Usable Pots:

• Usable are enameled or induction suitable pots, with a diameter of min 12cm. To test, if the pots are suitable, it can simply be tested with a magnet. If  the magnet keeps sticking to the pot bottom, the pot is suitable.

• Not suitable are pots made from Aluminum, copper, glass, ceramic and partly stainless steel.
  The pot bottom should be not too thin and not bended.

• Never heat an empty pot, this may cause discoloration and distortion

• You need to use pots and pans suitable for induction cookers

• Danger of burns!
  Never carry if the pot is hot and never place it on heatsensitive surfaces.

Generally
This appliance is for private and indoor use only and must not be used commercially. Please read the instruction manual carefully and keep it at a safe place. When the appliance is given to another person the instruction manual should be passed to that person, too. Only use the appliance as described in the instruction manual and pay attention to the safety information. No liability for damages or accidents will be accepted, which are caused by not paying attention to the instruction manual.

Safety information

• Persons with older cardiac pacemaker should ask the doctor before using this appliance.
• Do not keep the appliance unattended during the usage.
• Do not plug with wet hands.
• Do not plug into a socket where several other appliances are plugged in.
• Do not use if the plug cord is damaged or when the power plug does not fit the socket securely.
• Do not modify the parts, or repair the unit by yourself.
• Do not use the unit near a flame or wet places.
• The appliance can be used by children aged 8 and above and persons with limited physical, sensory or mental capabilities or lack of experience/knowledge, provided that are supervised or have been provided with instruction in the safe use of the appliance and have understood the resulting dangers. Children must not use the packaging as a plaything. Cleaning and user maintenance must not be carried out by children unless they are 8 years or older and are supervised.
• Children under the age of 8 must be kept away from the appliance and the connecting cable.
• The appliance must not be operated using a timer or a separate remote system!
• Do not place on unstable surfaces.
• Do not heat the pot empty or overheat it.
• Attention: The glass surface could show residual heat from heated pots.
• Never use the appliance, if the cable or the glass plate is damaged, cracked or dropped down.
• Never put pots, set of cutlery or any other metallic parts on the appliance. These parts could get very hot, when the cooker is turned on.
• To avoid any dangers, never change anything at the appliance or conduct any repair. Repairs and exchange of the power cord must only be done by an authorized dealer.
• Do not immerse the appliance in water or any other liquid (Danger of electric shock!). Protect the appliance from getting wet.
• If an extension cord is needed, makes sure it is suitable for the appliance. Unwind cable drums completely.
• Never carry, when there are still pots or pans on it.
• Never put more than 5 kg on the top of the plate. The glass surface could show residual heat from the heated pots.
• Use the unit with sufficient space around it. Keep the front side and either right or left side of the unit clear.
• Never use the unit on carpet or tablecloth (viny1) or any other low-heat-resistant article.
• Do not place a sheet of paper between the pot or the pan and the unit. The paper may get burnt.
• If the surface is cracked, switch off and take to the service center immediately.
• Do not block air intake or exhaust vent.
• Do not touch the top plate shortly after removing the pot or the pan, as the top plate will still be very hot.
• Do not place near objects which are affected by magnet, such as: radios, televisions, automatic-banking cards and cassette tapes.
• The supply cord must by replaced by qualified technicians.

How to Clean

• Disconnect plug and wait until it is cooled down. Clean after each use.
• Never immerse the device in Water.
• If the pots/pans are used without being cleaned, discoloration or cooked on stains may be caused.
• Do not use petrol, thinner, scrubbing brush or polishing power to clean the induction cooker.
• Wipe using dish washing agent and damp cloth.
• Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
• Never run water over the unit. (water gets inside may cause malfunction).
• The appliance can be used by children aged 8 and above and persons with limited physical, sensory or mental capabilities or lack of experience/knowledge, provided that are supervised or have been provided with instruction in the safe use of the appliance and have understood the resulting dangers.
• Do not immerse the appliance in water or any other liquid (Danger of electric shock!). Protect the appliance from getting wet.
• If an extension cord is needed, makes sure it is suitable for the appliance. Unwind cable drums completely.
• Never carry, when there are still pots or pans on it.
• Never put more than 5 kg on the top of the plate. The glass surface could show residual heat from the heated pots.
• Use the unit with sufficient space around it. Keep the front side and either right or left side of the unit clear.
• Never use the unit on carpet or tablecloth (viny1) or any other low-heat-resistant article.
• Do not place a sheet of paper between the pot or the pan and the unit. The paper may get burnt.
• If the surface is cracked, switch off and take to the service center immediately.
• Do not block air intake or exhaust vent.
• Do not touch the top plate shortly after removing the pot or the pan, as the top plate will still be very hot.
• Do not place near objects which are affected by magnet, such as: radios, televisions, automatic-banking cards and cassette tapes.
• The supply cord must by replaced by qualified technicians.

How to Clean

• Disconnect plug and wait until it is cooled down. Clean after each use.
• Never immerse the device in Water.
• If the pots/pans are used without being cleaned, discoloration or cooked on stains may be caused.
• Do not use petrol, thinner, scrubbing brush or polishing power to clean the induction cooker.
• Wipe using dish washing agent and damp cloth.
• Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
• Never run water over the unit. (water gets inside may cause malfunction).

Stand-By-Mode
Plug in the device
Press the On/Off button. A buzzer is sounding. If there is no program chosen within one minute, the appliance returns to the stand-by mode.
You can chose the functions power, temperature and time Power
Switch on the device and chose the function power level, a light shines and the display shows level 5. By pressing the button + – the Wattage can be changed in steps from 1 – 10:
1 = 500 Watt, 2 = 1050 Watt, 3 = 1200 Watt, 4 = 1350 Watt, 5 = 1400 Watt,
6 = 1550 Watt, 7 = 1650 Watt, 8 = 1750 Watt, 9 = 1850 Watt, 10 = 2000 Watt
The appliance is equipped with an overheating protection. When the pots/pans get too hot, then the appliance will switch off, a buzzer sounds and on the display appears E02. In that case, the “On/Off” button should be pressed and the appliance should cool down some minutes. After that the appliance is working without problem again.

Temperature

This function is suitable for roasting meat and vegetables.
Place the pot in the middle of the cooking area.
Touch ON/OFF one time and after that 2 times the function button. A red LED bellow the temperature symbol shines and in the display 120 can be seen. The cooling fan starts to work. With the buttons + – the temperature can be adjusted in 20 degree steps. During the cooking the temperature can be adjusted at any time. The build in sensor keeps the temperature at about the adjusted temperature. The temperature can be adjusted from 60°C up to 240°C. When the failure code E0 is in the display then the used pot or pan is not suitable induction cookers. The appliance beeps and after ca 30 Sec the appliance will switch to the stand-by mode.

Timer
The temperature or power must be adjusted first, as described above. Touch the function button so many times, until the red LED bellow the Timer symbol is blinking. The display shows „0“. Now there is 5 seconds time to adjust the time by pressing the button + – in steps of 5 minutes. The time can be adjusted from 5 to 180min. Pressing the button – decreases the time by 5 minutes.
When the + or – button is pressed one time the time increases or decreases by 5 minutes. If you want to change the time during the cooking touch the function button until the timer LED is blinking. Now you have ca 5 seconds time to change the timer setting. When the function temperature and the timer is used and it is the intention to switch to the power mode or temperature, the function button needs to be touched as many times as both lights shine and the display shows the remaining time. When the ON/OFF button is touched during the cooking then the program will be deleted and the appliances switches to the stand-by mode. If the adjusted time runs out, the appliance will switch to the stand-by mode.

Disposal:

Packaging disposal:
Do not throw away the package materials. Please put it in the recycling bin.
Gift box: Paper, should be put to the old paper collection point.
Plastic packaging material and foils should be collected in the special collection containers.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Service and Repair:
If the appliance must be repaired, plaese get in touch with your trader or with the manufacturer:

Steba Elektrogeräte GmbH & Co. KG
Pointstraße 2, D-96129 Strullendorf
Zentrale: Tel.: 09543-449- 0
Elektro@steba.com
Fax: 09543-449-19
Vertrieb: Tel.: 09543-449-17
www.steba.com
Tel.: 09543-449-18
Art. Nr. 480-13097 Stand 09/2015

References

• Steba Elektrogeräte | Qualität. Verlässlichkeit. Kompetenz.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>