Steba HK30 Glass Ceramic Hob Instruction Manual

HK30 Glass Ceramic Hob
Instruction Manual

HK30 Glass Ceramic Hob

220 – 240 V~; 50/60 Hz; 2000W
www.steba.com

Cookware

• Applicable are all pots and pans made of metal, glass or ceramics. Minimum diameter 12 cm, but not larger than the ring on the glass plate.
• Make sure that the bottom of the pot is flat and not too thin, as this will influence the temperature regulation negatively.
• Place the appropriate pot / pan (minimum diameter 12 cm) in the middle of the plate.
• Caused in the composition of the materials of the pot, some noise might be heard during cooking.

Generally
This appliance is for private and indoor use only and must not be used commercially. Please read the instruction manual carefully and keep it at a safe place. When the appliance is given to another person the instruction manual should be passed to that person, too. Only use the appliance as described in the instruction manual and pay attention to the safety information. No liability for damages or accidents will be accepted, which are caused by not paying attention to the instruction manual. Remove all packaging and sticker. Wash up all parts carefully (see cleaning).

Safety information

• Connect and operate the appliance in accordance with the specifications shown on the rating label.

• Do not use if the plug cord is damaged. Verify before every use.

• Do not plug with wet hands.

• Connect the power plug to a properly installed and easily accessible socket only.

• To unplug the power plug, always pull the plug – not the cable.

• Plug off the appliance after each use or in case of failure.

• Do not pull at the cord. Don’t pull it over edges and don’t bend it too much.

• Keep the cord away from hot parts.

• The appliance can be used by children aged 8 and above and persons with limited physical, sensory or mental capabilities or lack of experience/knowledge, provided that are supervised or have been provided with instruction in the safe use of the appliance and have understood the resulting dangers. Children must not use the packaging as a toy. Cleaning and user maintenance must not be carried out by children unless they are 8 years or older and are supervised.

• Children under the age of 8 must be kept away from the appliance and the connecting cable.

• Children should be supervised to ensure that they do not play with the appliance or packaging material (e.g. Plastic Bags).

• The appliance must not be operated using a timer or a separate remote system!

• Never leave the appliance unattended when in use.

• Do not leave the appliance outdoors or in a damp area.

• Never immerse the unit in water.

• Never use the device after a malfunction, e.g. if it felt down or has been damaged in any other manner.

• The manufacturer is not liable for damage which is occurring due to the usage of the appliance in a different way as described or a mistake in the handling has been made.

• To prevent injury, repairs such as replacing a damaged cord, should only be carried out by a customer service. Only original spare parts have to be used.

• The device gets hot, only transport after it cooled down and without cookware on top.

• Only use the device as described in this manual.

• This appliance is intended to be used in household and similar applications such as:
  o staff kitchen areas in shops, offices and others working environments
  o by clients in hotels, motels and other residential type environments
  o bed and breakfast type environments.

• Attention! Device gets hot. Danger of burns!
  While using the device, the surface can get very hot! Do not place the appliance on a sensitive surface (e.g. painted furniture) and keep a distance of at least 70cm to burnable materials.

• If an extension cable is used, it has to have a cross-section of 1,5mm². A cable drum must always be unwound.

• If a GS-tested 16 A multi-pin extension is used, it may not be charged with more than 3680 watts due to fire hazard.

• Make sure that children do not tease the cable or that a trip hazard occurs.

• The device must always be disconnected from the power supply if it is not supervised and before assembling, disassembling or cleaning.

• Risk of electronic shock! Do not put any sharp objects into the ventilation slots. Do not use the device if there are cracks in the glass plate.

• Never place empty pots, cutlery or other metallic objects onto the device. Those objects will get hot! Do not heat cans, they can explode.

• Do not place a sheet of paper or metal foil between the pot or the pan and the device.

• Do not load the glass surface with more than 8kg.

• In order to protect the electronic parts, the ventilation runs for a couple of minutes after the device has been turned off.

• The glass surface can have a residual heat after cooking. The symbol “H” is shown in the display.

• Attention! Do not place hot pots or pans onto the control panel! Not warranty payments!

• Do not use the device if unsupervised. Oil and fat can catch fire if they get too hot. In case of grease fire unplug and never extinguish with water! Cover the pot with a lid, plate, or similar.

Cleaning

• Attention! Pull the plug before cleaning and allow the device to cool down.
• Never immerse the unit into water.
• Hygiene: Please always clean the device to avoid bacteria and mold formation.
• Pay attention that no liquids can get into the device through the air intakes.
• A discoloration or storing can be caused if pots are used which are not clean at the bottom.
• Use a damp cloth and some detergent for cleaning.
• Do not use any abrasive milk, polishing wool or solvent for cleaning.
• Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.

Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot stoves). Only use it on a even, stable, non-metallic and a heat resisting surface. It is important that no inflammable items are near to the device. Do not place the device on the edge of the table so that it cannot be touched by children or fall down when touched.

Getting started

• Plug in the device, the display lights up and a beep can be heard.
• Press the ON / OFF button . The display shows – – – – and the ventilation starts running.
• Press the button . The display shows 900 watts and the device starts heating up the small cooking plate. During operation, the power can be changed using the +/- buttons as followed: 100 / 400 / 600 / 700 / 800 / 900 / 1000 watt.
• Press the button in order to select the bigger cooking plate. The display shows 1800 watts and the device starts heating up the big cooking plate. During operation, the power can be changed using the +/- buttons as followed: 200 / 800 / 1200 / 1400 / 1600 / 1800 / 2000 watt.
• Once the power has been set, press the timer button . The time can be set in steps of 5 minutes from 0 to 180 minutes.
• The display alternately shows the selected power and remaining time. During operation, the time can be changed by pressing the timer button and changing the values with +/-.
• After the time runs out, the device beeps ad the display shows the residual heat symbol “H”. the ventilation continues for about 10 minutes.
• For safety reasons, the timer should always be set so that the food does not burn or be forgotten! If no timer is set, the device automatically shuts off after 2 hours.
• If the current program has be to be stopped, press the button . The display shows “P”. the remaining time and the set power are stored. Press the button again to continue the program.
• Press the key lock to lock all buttons. By pressing again (3 seconds), the key lock is cancelled.

Residual Heat “H”
After the program has finished, or if the device has been switched off with ON / OFF, it beeps and the residual heat indicator “H” lights up. The ventilation runs for about 10 minutes to protect the electronics. Only then pull the mains plug.

Troubleshooting

Dear Client,
Thank you for buying this STEBA product. The following table will help you with problems that may occur when using your device. For many problems there is a simple solution, because not everything that appears like a malfunction must be serious. Please check the following list before contacting our customer service.

• Check the fuse
Plate does note heat any more| • Timer run out| • Rest the timer
Error Code “El”| • Temperature inside the device is too high
• Ventilation does not work| • Is the air intake blocked?
• Let the device cool down
• Contact service
Error code “E2”| • Overheating of glass plate
• Sensor defect| • Let the device cool down
• Contact service

Correct Disposal of this product
** This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Packaging disposal: Do not throw away the package materials. Plearecycling bin.
Gift box:** Paper, should be put to the old paper collection point.
Plastic packaging material and foils should be collected in the special collection containers.

Service and Repair:
If the appliance must be repaired, please get in touch with your trader or with the manufacturer:

STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18,
Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: elektro@steba.com
Internet: http://www.steba.com

References

• Steba Elektrogeräte | Qualität. Verlässlichkeit. Kompetenz.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>