ergomotion RF406 Remote Control User Manual
- June 4, 2024
- ergomotion
Table of Contents
ergomotion RF406 Remote Control
Function Picture
Head Lift +
Press and maintain, head lift stretches out
Head Lift –
Press and maintain, head lift retracts
Foot Lift +
Press and maintain, foot lift stretches out
Foot Lift –
Press and maintain, foot lift retracts
zeroG button test
Click zeroG button, then actuator will move to zeroGposition, during the
movement, click any button to stop it;
Lounge test
Click Lounge butoon, actuator will move in to Lounge position;
TV/PC test
Click TV/PC butoon, actuator will move in to TV/PC position;
FLAT test
Click FLAT butoon, actuator will move in to lowest position;
For pairing
Button is inside the battery cover for pairing.
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirment. The
device can be used in portable exposure condition without restriction.
Canada, Industry Canada (IC) Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment.The device has been evaluated to meet general RF
exposure requirement
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>