Sideclick Apple TV 4K 2nd Gen Universal Remote Attachment User Guide

: June 10, 2024
: Sideclick

Table of Contents

Sideclick Apple TV 4K 2nd Gen Universal Remote Attachment
Product Information
Product Usage Instructions
- Getting Started
Tips
What’s Included
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Sideclick Apple TV 4K 2nd Gen Universal Remote Attachment

Product Information

The Sideclick RemotesTM is a universal remote attachment that streamlines your streaming experience. It is a simple and easy-to-use device that provides fast setup and long battery life. It allows you to control multiple devices with just one remote. The Sideclick RemotesTM operates under True Bloom LLC and is not affiliated with Apple Inc. Apple TV is a trademark of Apple Inc.,registered in the United States and other countries.

Product Usage Instructions

Getting Started

Select and attach your clip
- Your Sideclick is packaged with the correct adapter clip installed. However, if your clip is ever detached from your Sideclick remote, you can re-attach by following steps 2 and 3.
- Line up tabs on Sideclick remote with keyholes on the side of the clip.
- Press clip against Sideclick remote and slide clip up until it locks in place.
- If you have an AirTag that you would like to install in your Sideclick, pop out the AirTag blank from the back of the clip and insert Airtag, silver side first until it snaps in place.
Install your remote
Slide your device remote into the slot on the Sideclick remote until it snaps into place.
Program your Sideclick
- On Sideclick, hold down the buttons simultaneously until the LED lights solid.
- Position your Sideclick remote and the device remote you are learning from on a table, head to head, approximately 1 inch apart.
- Press and release the Sideclick button you wish to program. The LED will start blinking.
- Press and hold the button you want it to learn from on your device remote. The LED will blink 3 times indicating a successful learn, then will return to solid indicating you are ready to program other buttons. If the LED does not return to solid, a problem in programming has occurred. Exit programming mode via step 6 and try again.
- While LED is on solid, repeat steps 3 & 4 for each button you would like to program.
- To exit programming mode, press the simultaneously and the LED will turn off. You can also wait approximately 10 seconds and it will exit programming mode automatically.
- Your Sideclick is now ready to use.
Removing your clip
- Using your fingertip, slide the release tab to the right as indicated in the picture.
- While maintaining pressure on the release tab, slide clip down and then away from remote.

Tips

Make sure your device remote is fully charged and has fresh batteries before programming it with your Sideclick remote. Also, make sure that your Sideclick remote is fully charged before use. Please visit our website, www.sideclickremotes.com for additional information including: