AMBIEN TECH WARM-WSx-SA Wall Switch Sensor Installation Guide
- June 10, 2024
- AMBIEN TECH
Table of Contents
Wall Switch Installation
Installation Instructions
P/N:TONE-WSx-SA | WARM-WSx-SA
Item Identification
Wall Box
- A standard single-gang wall box sized 3 x 2 x 2 1/2 cm will service Dimmer
- Not compatible with multi or double Mud Rings.
- When using a retrofit gang box (cut in box) you might need to recess the ears.
Maximum Load
| Input Voltage | Max Load |
|---|---|
| 120VAC | 700W |
Before You Begin
To avoid fire, shock, or death, turn the power Off at circuit breaker and test to ensure the power is Off before wiring.
Prepare Wall Box Wires
- Make sure that the ends of the wires from the wall box are straight (cut if needed).
- Strip the wire insulator for each wire inside the wall box as shown here:
Wire Wall Switch
Connect wires according to the wiring diagram below.
Wiring Description (Using wire connectors)
- Connect the green (or bare copper) wire from the wall box to the green Wall Switch wire .
- Connect the line/hot wire from the wall box to the black Wall Switch wire.
- Connect the black LED Driver wire to the red Wall Switch wire.
- Connect the white wire from the wall box to the white LED Driver wire and the white Wall Switch wire.
Mount the Wall Switch
Mount the Wall Switch into the wall box using the screws provided.
Restore Power
- Turn the power On at the circuit breaker.
- Verify 120V with a Voltmeter
Mount the Wall Switch
Mount the Wall Switch into the wall box using the screws provided.
Item Identification
Pairing
If you are installing more than one Wall Switch unit, all others must be switched Off while pairing.
- Make sure both sliders are set to the top and the Wall Switch is switched Off.
- Switch the power On at the circuit breaker.
- Turn On the Wall Switch, the green LED Indicator will blink while pairing.
- After up to 15 seconds, your LED fixture will be paired with the Wall Switch.
- To verify pairing is successful, move the sliders and ensure that the LEDs respond accordingly.
- If youre installing a smart wall switch Scan the QP code to download the app. Follow the instructions to connect to the SmartAir App.
- If pairing is not successful press the Wall Switch pairing / reset button.
Connect to the SmartAir App
- Scan the C212 code to download the App. Follow the instructions to connect to the SmartAir App
Operation – Tunable White Wall Switch
Customer Assistance
For technical questions regarding the installation or operation of this product, please contact our customer support team:
347-334-6368 ext 3
www.ambientechinc.com
Caution
To reduce the risk of overheating and possible damage to other equipment,
do not install to control a receptacle, A motor-operated appliance, or a
transformer-supplied appliance.
“GRADATEURS COMMANDANT UN BALLAST – AFIN DE REDUIRE LE RISQUE DE SURCHAUFFE ET
LA POSSIBILITE D’ENDOMMAGEMENT A D’AUTRES MATERIELS, NE PAS INSTALLER POUR
COMMANDER UNE PRISE, UN APPAREIL A MOTEUR,”
FCC/IC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Operation – Dim-to-Warm Wall Switch
Troubleshooting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>