JBL TUNE520BT Wireless Headphones User Guide
- June 10, 2024
- JBL
Table of Contents
JBL TUNE520BT Wireless Headphones
WHAT’S IN THE BOX
APP
JBL Headphones
Power On & Connect
- To enter pairing mode again, power off and hold for 5 seconds.
Multi-point connection
CONTROLS
- Enable advanced controls by connecting your JBL TUNE520BT to JBL Headphones App .
DO MORE WITH THE APP
Charging
FACTORY RESET
led behaviors
TECH SPEC
- Model: TUNE520BT
- Driver size: 33 mm/ 1.3” Dynamic Driver
- Power supply: 5 V 1 A
- Weight: 157 g/ 0.35 lbs
- Battery type: Lithium-ion polymer (450 mAh/ 3.7V)
- Charging time: 2 hrs from empty
- Music playtime with BT on: Up to 57 hrs
- Talk time: Up to 35 hrs
- Frequency response: 20 Hz – 20 kHz
- Impedance: 30 ohm
- Sensitivity: 102 dB SPL@1 kHz
- Maximum SPL: 95 dB
- Microphone sensitivity: -40 DVB/Pa@1 kHz
- Bluetooth version: 5.3
- Bluetooth profile version: HFP 1.7.2, AVRCP 1.6.2, A2DP 1.3.2
- Bluetooth transmitter frequency range: 2.4 GHz – 2.4835 GHz
- Bluetooth transmitter power: ≤ 6 dBm (E.I.R.P)
- Bluetooth transmitter modulation: GFSK, π/4-DQPSK, 8DPSK
- Maximum operation temperature: 45 °C
IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaging over one gram of tissue.
Device types: (IC: 6132A-TUNE520BT) has also been tested against this SAR
limit According to this standard, the highest SAR value reported during
product certification for head use is 0.023 W/Kg. The device was tested for
typical bodily operations where the product was kept 0 mm from the head. To
maintain compliance with IC RF exposure requirements, use accessories that
maintain a separation distance of 0mm between the
user’s head and the back of the headset. The use of belt clips, holsters and
similar accessories shall not contain metal parts in its assembly. Use of
accessories that do not meet these requirements may not comply with IC RF
exposure requirements and should be avoided.
Head operation
The device was subjected to a typical head manipulation test. In order to
comply with RF exposure requirements, a minimum separation distance of 0 cm
must be maintained between the user’s ear and the product (including the
antenna). Head exposure that do not meet these requirements may not meet RF
exposure requirements and should be avoided. Use only the supplied or approved
antenna.
WARNING
DO NOT ATTEMPT TO OPEN, SERVICE, OR DISASSEMBLE THE BATTERY | DO NOT SHORT CIRCUIT | MAY EXPLODE IF DISPOSED OF IN FIRE | RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN INCORRECT TYPE | DISPOSE OR RECYCLE USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
Product specifications and app screens are subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>