TANDD B32TR Thermo Recorder Instruction Manual
- June 11, 2024
- TANDD
Table of Contents
TANDD B32TR Thermo Recorder Instruction Manual
Model No. TR32B
Safety Instructions and Specifications
Thank you for purchasing our product.
Please read carefully the following safety instructions and specifications to
prevent damage to personnel and property, and to ensure safe and proper use of
this product.
Explanation of Symbols
To Prevent Serious Accidents
DANGER
Places NOT Suitable for Installation and Storage
DANGER
- Areas exposed to excessive vibration
- Areas exposed to excessive smoke, dust or dirt.
- Areas exposed to direct sunlight
- Areas exposed to water leakage
- Areas subject to condensation or wet areas
- Areas subject to direct flames or heaters, as well as areas in which hot air accumulates and creates extremely high temperatures
- Areas exposed to static electricity
- Areas exposed to strong magnetic fields
Precautions for Battery
CAUTION
- There is a risk of fire or explosion if battery is replaced by an incorrect type. Use and replace only with correct size and type (AA alkaline) of battery.
- Do not disassemble, modify, mechanically crush or cut the battery, as it may cause battery leakage, overheating, explosion or fire.
- Do not dispose of a battery into fire or a hot oven as this can result in an explosion.
- Do not leave a battery in an extremely high temperature surrounding environment or subjected to extremely low air pressure that can result in an explosion or the leakage of flammable liquid or gas.
- Do not install the battery in the wrong direction. Doing so may result in product malfunction, battery leakage, overheating or explosion.
- If battery fluid gets on your eyes or skin, wash thoroughly with clean water. See a doctor immediately if it gets in your eyes.
- The supplied battery is non-rechargeable and should not be recharged.
- Use in high or low temperature environments will result in a shortening of the battery life.
- If the unit is not to be used for a long period of time, remove batteries. Leaving batteries inside the unit may cause battery leakage and malfunction.
Others
CAUTION
- Use the product in the specified operating environment, and do not use in any other purposes than those intended.
- If the product gets dirty, wipe it with a clean cloth.
- Battery terminals may provide insufficient contact due to age or vibration. This may lead to data loss.
- Please be careful not to let a third party know of your registration code. The registration code cannot be reissued or changed.
Compliance Information
< For FCC Model>
FCC and ISED Statement
This device complies with part 15 of FCC Rules and Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party :
TandD US, LLC
Santa Fe, New Mexico
https://tandd.com/
FCC Class B Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
ISED Class B Statement
This Class B digital apparatus complies with Canadian ICES-003.
FCC/ ISED Radiation Exposure Statement
This equipment complies with FCC/ISED radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules as this
equipment has very low levels of RF energy.
< For CE Model>
CE Statement
Hereby, T&D Corporation declares that the radio equipment type TR32B Series is
in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: tandd.com/manual/
< Important Notice>
Wireless products cannot be used in countries other than where those products
have been approved for use, according to that country’s wireless
regulations.T&D Corporation shall in no manner whatsoever take responsibility
for the usage of these products, nor be liable in any manner for legal
consequences stemming from the usage of these wireless products in unapproved
areas.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by T&D Corporation is under license.
Product Specifications
1: Battery life varies depending upon multiple factors including ambient temperature, recording interval, frequency of communication, and battery performance. All estimates are based on operations carried out with a new battery and are in no way a guarantee of actual battery life.
2: Estimated battery life when recording data at an interval of more than 10 seconds and collecting data once a day.
*3: Free software download and information on OS compatibility is available on the Software page of our website at tandd.com/software/.
The specifications listed above are subject to change without notice.
Disclaimer
In order to properly use this product, please carefully read all attached documents before using.
- All rights of the attached documents belong to T&D Corporation. It is prohibited to use, duplicate and/or arrange a part or whole of this and attached documents without the permission of T&D Corporation.
- Microsoft® and Windows® are registered trademarks of Microsoft Corporation USA and are binding in the USA, Japan and all other countries.
- Google, Android, and Google Play are trademarks or registered trademarks of Google Inc.
- Apple and App Store are trademarks or registered trademarks of Apple, Inc. in the U.S. and other countries.
- The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by T&D Corporation is under license.
- All registered trademarks, company names, product names and logos mentioned herein or for products being used are the property of T&D Corporation or of their respective owners.
- Specifications, design and other contents outlined in this and attached documents are subject to change without notice.
- Please follow the safety precautions outlined in this document carefully. We cannot guarantee nor are we responsible for safety if this product is used in any manner other than was intended.
- We are not responsible for any damage, malfunction or trouble, whether direct or indirect, caused by the use of our product.
- On-screen messages in this and attached documents may vary slightly from the actual messages.
- Please note that this and attached documents have been written based on the presupposition that details about contracts with an Internet provider, specific network environments and the setup of any other necessary equipment to enable network connection has already been taken care of by the User and that connection has been confirmed as workable. T&D Corporation shall not be responsible for any damages which a contractor, a user or a third party may suffer, whether direct or indirect, due to the inability to communicate or use communication devices.
- Please notify the shop where you purchased this product or T&D Corporation of any mistakes, errors or unclear explanations in this and attached documents. T&D Corporation accepts no responsibility for any damage or loss of income caused by the use of our product.
- Accompanying documents cannot be reissued, so please keep them in a safe place.
- Please read the warranty card and provisions for free repair carefully.
© Copyright T&D Corporation. All rights reserved. 2023. 3 16504740048(1st Edition)
Read More About This Manual & Download PDF:
References
- 各種お問合せ・修理・校正|T&D-公式-
- Manuals & Help Downloads | Data Logger Products | T&D Corporation
- Software/Apps | T&D Corporation
- Data Management Solutions | T&D Corporation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>