CULT-WERK HD-BRO120 Dash Cover Instruction Manual

HD-BRO120/BRO121
Dash Cover
Instruction Manual

Mounting instructions

Dismantle the original Dash Cover

1. remove seat
2. loosen screws (11 & 12) and lift dash cover.
3. disconnect speedometer and tachometer and put away the original dash cover – the original gasket (20) is used again.

Fitting the Dash Cover from Cult-Werk
To fit the dash cover, it is necessary to shorten and drill the original bracket on the tank.
TIP: let the mounting bracket rest on the tank and place it against the original tabs, then mark the drill hole.

1. fix the supplied fixing bracket to the shortened tabs with the screws (M6x16). 2.
2. Fit the original gasket on the Cult-Werk dash cover.
3. fix the dash cover – at the rear with the original screw (11), at the front with the M6x12 screw. on the mounting bracket
   Tightening torque: 4 to 7Nm
   We recommend using a medium-strength screw lock (e.g. LOCTITE 243, blue) for all screws.

Version 10/22

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>