ZLPOWER 360 Photobooth Machine User Guide
- June 11, 2024
- ZLPOWER
Table of Contents
ZLPOWER 360 Photo booth Machine
Attention
- Before using, please check whether the power cord, base LED Strip cord and other items are stuck on the rotating table or not, to prevent the cables from being damaged.
- For users safety, don’t jump hard on the Stage.
- Don’t make the edge of the Stage bear too much weight, better distribute the weight evenly on the stage.
- The Stage should be adjusted paralleled to the ground by rotating the foot cup before using.
- Do not stop the rotating rod deliberately when it was running.
- Do not put heavy objects on the Angle Adjuster and Selfie Telescopic Rod.
- Children should not use it alone, but must be accompanied by an adult.
- Pls take off the foot cups when put the photo booth into the flight case for transportation.
Component Introduction
The attachments received are subject to
installation Guide
Step1: Take the Stage out of 1he package, Do not cut off the black
plastlcties, which are used to de up the wire and control box. Install all the
8 Foot CUPs and adjust the Stage parallel to the ground. Than connect the AC-
DC adapter to the Motor Controller.
Step 2: Install 1he Angle Adjuster, and lock It with Fixed Screw.
Step 3:
lnslall 1he Selfie Telescopic Rod.
Step 4:
Stick the LED Strip to the base and conned It to 5V Adapter (for LED Strip)
Steps5 : Install Ring Light.
Step 6 :
Install Famed Bracket and Phone Hoklerli.
Step7:
Power bank. lithium belt8ry connec11on and usage(Power Bank and lithium
battery al9 not our tantara aoceeeorfee). The Ring Light 8h0Uld connect with
,USB port of the power bank. The motor controller should connect with the
llthlum battery a DC 24V power port And the LED strip should connect with the
lithium battery s DC sav use port.
-
Lithium Battery.
-
Power switch of the Battery.
-
(3 DC 12V output port. (4 DC 24V output port. Supply the photo booth power with this port connection.
-
Also this is the Lithium Battery charging port.
-
5V USB port, connected with the LED Strip.
-
Motor Controller.
-
Ring Light USB connection with Power Bank.
-
Brightness Increase Button.
-
Brightness Decrease button.
-
Temperature Switch.
-
Power Button.
Operation Instructions
Install suitable batteriee tor all remote controls(CR-2032).
Power~ the AC-DC adapter.
Plug the two USB(Ring Light& LED Strip} into the power bank and 5V adapBr.
Remote Control lnstructlorls
Light Brand Control Instructions
Installation Guide
A diagram to explain the overall structure in detail.
