SALUS SB600 Smart Button Instruction Manual
- June 11, 2024
- SALUS
Table of Contents
SALUS SB600 Smart Button
Product Information
The Smart Button, with model number SB600, is a device used to trigger the One touch and My Status rules that have been created for the Salus Smart Home system. While these rules are usually triggered through the Salus Smart Home app, the Smart Button provides an additional method. This product is designed to be used exclusively indoors and must be used with the Universal Gateway (UG600/UGE600) and the Salus Smart Home App. It is compliant with the essential requirements and other relevant provisions of Directives 2014/30/EU, 2014/35/EU, 2014/53/EU, and 2011/65/EU. The full text of the EU Declaration of Conformity is available at www.saluslegal.com. It is important to use this product in accordance with regulations and keep it completely dry. Before cleaning the device with a dry towel, disconnect it from any power source.
Product Usage Instructions
- Install batteries in the Smart Button.
- Follow the on-screen instructions to connect the Smart Button to the Salus Smart Home system through the Universal Gateway and the Salus Smart Home App.
- During initialization, the LED will light up for 2 seconds and then flash until the network is found, up to a maximum of 20 times.
- Once the Smart Button is connected to the Salus Smart Home system, the LED will stop flashing.
- To reset the device, remove one battery and keep the reset button pressed when inserting it again.
If you require further assistance or support, please contact SALUS Controls via email at support@salus-controls.de (DE/NL/FR) or tech@salus-tech.com (UK), or call them at +49 6108 8258515 (DE/NL/FR) or +44 (0) 1226 323961 (UK).
Introduction
The Smart Button is used to trigger the “One touch” and “My Status” rules that you have created for your Salus Smart Home system . Normally “One touch” and “My Status rules are triggered via the Salus Smart Home app, however the Smart Button provides an additional Method. This product must be used with the Universal Gateway (UG600/UGE600) and the Salus Smart Home App. Go to www .salus-smarthome.com for the PDF version of the manual.
Product Compliance
This product complies with the essential requirements and other relevant
provisions of Directive 2014/30/EU, 2014/35/EU, 2014/53/EU and 2011/65/EU. The
full text of the EU Declaration of Conformity is available at the following
internet address: www.saluslegal.com.
Safety Information
- Use in accordance with the regulations.
- Designed to be used exclusively indoor.
- Keep your device completely dry.
- Disconnect your device before cleaning it with a dry towel.
INSTALLATION INSTRUCTIONS
During initialisation, the LED lights up for 2 seconds, then will flash until the network is found (max 20 times). When joined the LED will go off.
Follow the on screen instructions. Once connected, the LED will stop flashing.
Factory Reset
Remove one battery. Keep the reset button pressed when inserting back the battery.
Head Office:
SALUS Controls plc SALUS House Dodworth Business Park South, Whinby Road,
Dodworth, Barnsley S75 3SP, UK.
- T : +44 (0) 1226 323961
- E : sales@salus-tech.com
www.salus-controls.com
SALUS Controls is a member of the Computime Group Maintaining a policy of
continuous product development SALUS Controls plc reserve the right to change
specification, design and materials of products listed in this brochure
without prior notice. For PDF Installation guide please go to www.salus-
manuals.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>