HARMAN NTG7Q Infotainment System Instruction Manual
- June 11, 2024
- Harman
Table of Contents
User Instruction Manual NTG7Q
Infotainment System
Model: NTG7Q MID
Model: NTG7Q HIGH
Model: NTG7Q PREMIUM
Model: NTG7 PREMIUMPLUS
Brand: Mercedes-Benz
Inputs for User Manual
NTG7Q MID, NTG7Q PREMIUM NTG7Q HIGH
Technical Information
1.1 Materials
respectivamente EN ISO 1043.Declaration of Conformity to RED regulation
1.2 Declaration of Conformity to RED regulation 2014/53/EU
Declaration of Conformity (DoC)
* Hereby, Harman Becker Automotive Systems GmbH declares that the radio
equipment type NTG7Q MID, NTG7Q HIGH, NTG7Q PREMIUM is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet Address: (1)
1.3 Used Frequency spectrum and maximum radio-frequency power transmitted**
Bluetooth:
WLAN:
WLAN:
GNSS:
AM:
FM:
DAB:
DVB:| 2400-2483.5 MHz
2,4 GHz (2400 MHz –
5 GHz (5150-5250 MHz 1575,42 MHz +/- 2 MH
531-1602 kHz
87.5-108 MHz
174-240 MHz
170-230 MHz
470-694 MHz| 2483.5 MHz)
5725 MHz – 5875 MHz
( Receivingonly)
Receiving only)
Receiving only
Receiving only)
Receiving only)
Receiving only)| <10dBm
<20dBm
<14dBm
————
————
————
————
————
————
---|---|---|---
1.4 Manufacturer
Harman Becker Automotive Systems GmbH
Becker-Goering-Strasse 16
76307 Karlsbad,
Germany
1.5 FCC/ISED statements (North America) NTG7Q
FCC ID: T8GNTG7QMID | & | IC: 6434A-NTG7QMID |
---|---|---|
FCC ID: T8GNTG7QHIGH | & | IC: 6434A-NTG7QHIGH |
FCC IC: T8GNTG7QPRE | & | IC: 6434A-PREGNANT |
FCC IC: T8GNTG7QPRE | & | IC: 6434A-NTG7QPRE |
Modification statement:
The party responsible for the compliance has not approved any changes or
modifications to this device by the user. Any changes or modifications could
void the user’s authority to operate the equipment.
Wireless notice:
This device complies with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS‐102 of the ISED radio frequency (RF) Exposure rules. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device will be installed into different car models, using a specific
installation setup for each carline.
The device has two different antennas that will be installed into different
car positions resulting in a distance minor to 20 cm to the closest passenger:
– “Pin3/Co-pilot” antenna will be installed at distances between 13.17 cm and
more than 20 cm to the closest car passenger depending on the carline model.
– “Pin4/Pilot” antennas will be installed at distances between 17.125 cm and
more than 20 cm to the closest car passenger depending on the carline model.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
1.6 Argentina 1.7 China (Mainland)
Part name | Toxic and hazardous substances and elements |
---|---|
Pb | Hg |
Bottom Chassis, Chassis Top, Rear Cover, Screws, Labels, Gapfiller, etc | 0 |
0 | 0 |
Connectors | X |
PCB ASY | X |
Fan | X |
This table was developed according to the provisions of SJ/T 11364.
O: The content of such hazardous substance in all homogeneous materials
of such component is below the limit required by GB/T 26572
X: the content of such hazardous substance in a certain homogeneous
material of such component is beyond the limit required by GB/T 26572
(Enterprises may further explain the technical reasons for ticking “X” in the
table above according to their actual situation herein.
1.8 Taiwan
following information has to be included in the user’s manual:
- Product name
- Model name
- Trade mark or applicant name
- For BSMI safety, rating (voltage and current) and operation temperature.
- NCC caution statement. The following warning statement should be written in traditional Chinese:
‘Any changes or modifications are not allowed. The product is subject to not
cause harmful interference to radio communications and air flight safety. If
this equipment does cause interference, which can be determined stop shipping
till the product is improved.
This device may not cause harmful interference, and this device must accept
any interference received, including interference that may cause undesired
operation.’
1.9 Mexico declaration:
1.10 Japan MIC declaration (HIGH and PREMIUM ONLY)
In order to prevent users from accidentally connecting appliances directly to
telecommunications line facilities without any approval this note has to be
granted:
This product cannot be connected directly to the telecommunications lines (or
public wireless LANs) of any telecommunication carriers (e.g., mobile
communications carriers, fixed communications carriers, or internet
providers). in the case of connecting this product to the internet, be sure to
connect it via a router
1.11 Indonesia
Model / Product| Cert.-Label info| U/M info, QR code| U/M
alert sign
---|---|---|---
NTG7Q MID production: XXX| UNKOWN| Barcode unknown|
NTG7Q HIGH production: XXX| UNKOWN| Barcode unknown|
NTG7Q Premium production: XXX| UNKOWN| Barcode unknown|
1.12 Samoa
The trademark will be highlighted on the packaging, warranty forms,
instruction manual and leaflets,websites, and equipment or device. A height of
at least 3mm is recommended.
Pan German Motors Ltd.
No. 5, Apple Road, Yangmei Dist.,
Taoyuan, 32612, Taiwan
leo.lu@bmw.com.tw
Tel: +886 3 4827111 Ext. 267
Fax: +886 3 4816979
If required in Taiwanese:
First line is name, second the address.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>