Zelmer ZIR3000 Steam Iron User Manual
- June 11, 2024
- zelmer
Table of Contents
ZIR3000 Steam Iron
User Manual
ZIR3000 Steam Iron
WE WOULD LIKE TO THANKS YOU FOR CHOOSING ZELMER,
WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE.
WARNING
PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO USING THE PRODUCT.
STORE THESE IN A SAFE PLACE FOR FUTURE REFERENCE.
DESCRIPTION
A- Spray button
B- Shot of steam button
C- Steam regulator
D- Cover for filling opening
E- Output water spray
F- Self-cleaning button
G- Temperature Control
H- Temperature indicator light
I- Level mark for maximum filling
J- Power cord
K- Sole plate
Depends of the model you can find the special button Self-cleaning or you can find this function in the control of the steam.
SAFETY INSTRUCTIONS
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
If the supply cord is damaged it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
The iron must not be left unattended while it is connected to the supply
mains.
The plug must be removed from the socket-outlet before the water reservoir is
filled with water.
The iron must be used and rested on a flat, stable surface When placing the
iron on its stand, ensure that the surface on which the stand is placed is
stable.
The iron is not to be used if it has been dropped, if there are visible signs
of damage or if it is leaking.
Keep the iron and its cord out of reach of children less than 8 years of age
when it is energized or cooling down.
This device is designed for use at a maximum altitude up to 2000m above sea
level.
CAUTION Hot surfaces. Surfaces are liable to get hot during use.
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for
commercial or industrial use under any circumstances. Any incorrect use or
improper handling of the product shall render the warranty null and void.
Prior to plugging in the product, check that your mains voltage is the same as
the one indicated on the product label.
If you use one adaptor make sure it can reach 16 A and is provided with earth
socket
The mains connection cable must not be tangled or wrapped around the product
during use.
Do not use the device, or connect and disconnect to t supply mains with the
hands and/or feet wet. Do not pull on the connection cord in order to unplug
it or use it as a handle
Do not direct steam at people and animals.
Do not place the appliance under the tap to fill the water tank, or immerse it
in water or other liquids. Unplug the product immediately from the mains in
the event of any breakdown or damage and contact an official technical support
service. In order to prevent any risk of danger, do not open the device. Only
qualified technical personnel from the brand´s Official technical support
service may carry out repairs or procedures on the device. Only an official
technical support service centre may carry out repairs on this product.
Proceed according to maintenance and cleaning section of this manual for
cleaning.
B &B TRENDS SL. disclaims all liability for damages that may occur to
people, animals or objects, for the non-observance of these warnings.
BEFORE ITS FIRST USE
Before using the steam iron, please ensure you read the user manual and
understand all parts and features of the Steam Station. Be sure to remove any
packaging material and labels before using for the first time.
In the first use they can break off odors or fumes that sent quickly. Do not
spray for the first time on clothes and there may be traces of dirt on the
soleplate.
HOW TO USE
Always check whether a label with ironing instructions is attached to an
article to be ironed. Follow these instructions in all cases.
Turn the temperature control dial round to set the appropriate temperature
indicated in ironing instructions or in fabric label.
| MARKING | MATERIAL, FOR EXAMPLE |
|---|---|
| (1 dot) | Acetate, elastane, polyamida, polypropylene |
| •• (2 dots) | Cupro, polyester, silk, triacetate, viscose, wool |
| ••• (3 dots) | Cotton, linen |
Insert the main plug into the wall socket. The indicator light will turn on.
When the indicator light goes out you may start ironing.
WATER TANK FILLING
Unplug the iron before filling the water tank.
The device is designed for use with tap water. If the water in your area is
hard or semi-hard use mix tap water with distilled or decriminalized water
purchased in stores, in the ratio 2:1 and 1:1 respectively (distilled water:
tap water). Check with your water supplier to determine the type of water in
your area. Never use 100% distilled or decriminalized, rain water, softened
water, scented water, water from other appliances such as refrigerators, air
conditioners, dryers or other types of home water preparation water.
Open the cover for filling.
Slowly pour water through the water inlet.
Do not fill higher than mark on the water tank, in order to avoid spilling out
of water. The water tank should be emptied after each use.
SPRAYING
As long as there is enough water in the water tank, you may use the spray
button at any temperature setting during steam or dry ironing.
Press the spray button several times to activate the pump while you are
ironing.
STEAM IRONING
Set the temperature control dial to the desired position in accordance with
the manufacturer’s label. Set the variable steam control to the desired
position.
CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING
The steam iron can be used on the dry setting with or without water in the
water tank, it is best to avoid having the water tank full while dry ironing.
Turn the variable steam control to the minimum position.
Select the setting on the temperature control dial best suited for the fabric
to be ironed.
CAUTION: If the steam iron has been used for a long time, it is hot and
there is no water. Do not refill it with water until the steam iron cools
down.
SHOT OF STEAM
The shot of steam feature provides additional steam for removing stubborn
wrinkles. Turn off the variable steam control to the min position
Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the
powerful steam button in continuously and wait almost 5 seconds between
pressures.
VERTICAL IRONING
By pressing the shot-steam button at intervals you can also iron vertically
(curtains, hung garments, etc.)
NOTE: To prevent water leakage from the soleplate, do not keep the
powerful steam button in continuously and wait almost 5 seconds between
pressures.
WHEN YOU FINISHED IRONING
Set the temperature dial to the minimum position. Remove the main plug from
the wall socket.
Stand the iron on heel rest.
MAINTENANCE AND CLEANING
It is recommended to the self-cleaning every two weeks if the water in the
area is hard or semi-hard if frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply
and has completely cooled down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any
chemical solvents, as these will damage the surface.
Cleaning the soleplate; do not use scouring pads or harsh cleaners on the
soleplate as these will damage the surface. To remove burnt residue, iron over
a damp cloth while iron is still hot. To clean the soleplate, simply wipe with
soft damp cloth and wipe dry.
SELF-CLEANING
Fill the half of the water reservoir.
Set the temperature control to its maximum position. Insert the main plug into
the wall socket.
Allow the iron to heat up until the indicator light goes out.
Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of self-
clean, in case if not have this button change the steam control to the maximum
position.
Boiling water and steam will be ejected from the holes in soleplate with
impurities washed out Move the iron over an old (preferably) piece of cloth.
This ensures that the soleplate will be dry during storage.
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and
prevents scale build-up in the plate.
The resin filter is permanent and does not need replacing.
PLEASE NOTE: Do not use chemical additives, scented substances or
decalcifies. Failure to comply with the above-mentioned regulations leads to
the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate
fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the
point where no more steam comes out, but rather drops of boiling water that
can leave marks or stains. In these cases, the Anti-drip system automatically
activates to prevent vaporization, so that you can iron the most delicate
fabrics without risk of spoiling or staining them.
AUTO SHUT-OFF
An electronic safety device will automatically switch the heating element off
if the iron has not been moved more than 30 seconds in a horizontal position.
If in a vertical position, this will happen after 8 minutes. To indicate that
the heating element has been switched off, the auto-off pilot light will start
blinking.
When picking up the iron again, the auto-off pilot light will turn off. The
power pilot light will turn on. This indicates that the iron is heating up
again.
Wait for the power pilot light to turn off. Then the iron is ready for use.
TROUBLESHOOTING
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| SOLE PLATE IS NOT HEATING EVEN THOUGH IRON IS TURNED ON. | Connection problem |
Check main power supply cable, plug and outlet.
Temperature control is in MN position| Select adequate temperature
IRON DOES NOT PRODUCE STEAM| Not enough water in tank| Fill water tank
Steam control is selected in non- steam position.| Set steam control between
positions of minimum steam and maximum steam (see”iron chart”).
Selected temperature is lower than that specified to use with steam.| Select a
higher temperature
SPRAY FUNCTION DOES NOT WORK| Not enough water in tank| Fill water tank (see
“getting started”, no 2).
STEAM JET AND VERTICAL STEAM JET FUNCTION DOES NOT WORK| Steam jet function
was used very frequently within a short period.| Put iron on horizontal
position and wait before using steam jet function.
Iron is not hot enough| Adjust to higher temperature to steam ironing. Put
iron in vertical position and wait temperature indicator light turns off.
STEAM JET AND VERTICAL STEAM JET FUNCTION DOES NOT WORK| Steam jet function
was used very frequently within a short period.| Put iron on horizontal
position and wait before using steam jet function.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and
electronic devices, known as WEEE (Waste Electrical and Electronic Equipment),
provides the legal framework applicable in the European Union for the disposal
and reuse of waste electronic and electrical devices. Do not dispose of this
product in the bin, instead going to the electrical and electronic waste
collection centre closest to your home.
We hope that you will be satisfied with this product.
WARRANTY REPORT
B&B TRENDS, S.L. guarantees compliance of this product for the use for which
it is intended for a period of two years. In the case of breakdown during the
term of this warranty, users are entitled to repair or else the replacement of
the product at no charge if the former is unavailable, unless one of these
options proves impossible to fulfill or is disproportionate. In this case, you
can then opt for a reduction in price or cancellation of the sale, which must
be dealt with directly with the sales vendor. This also covers replacement of
spare parts provided that the product has been used according to the
recommendations specified in this manual for both cases, and has not been
tampered with by any third party that is not authorised by B&B TRENDS, S.L.
The warranty will not cover any parts subject to wear and tear. This warranty
does not affect your rights as a consumer in accordance with the provisions in
Directive 1999/44/EC for member states of the European Union.
USE OF WARRANTY
Customers must contact a B&B TRENDS, S.L. authorised Technical Service for
repair of the product. Since any tampering of the same by anyone not
authorised by B&B TRENDS, S.L., or the careless or improper use of the same
shall render this warranty null and void. The warranty must be fully completed
and delivered along with the receipt or delivery docket for the effective
exercise of rights under this warranty.
This warranty should be retained by the user as well as the invoice, receipt
or the delivery docket to facilitate the exercise of these rights. For
technical service and after-sales care outside the Polish territory, please
submit your query to the point of sale where you purchased the item or check
for further aftersales information at www.zelmer.com.
www.zelmer.com
SERIES: ZIR.
MOD: ZIR3000 STIRO
220-240V~ 50/60Hz 2560-3050W
Type: ES2342_02
Made in China
B &B TRENDS, S.L.
C. Cataluña, 24 · P.I. Ca N’Oller
08130 Santa Perpètua de Mogoda (Barcelona)
Spain